AquaScape 40040 Manual page 5

• The Controller Add-on Kit includes the control panel,
intake assembly, and tubing. Simply slide the second
control panel into the lid (Ex. 12), remove the rubber elbow
attached to the secondary power cable
(Ex. 13) and repeat the steps from above to complete
installation.
Ex. 12
SETTINGS
NOTE: If using the Smart Control App, skip down to the
next section (APP PAIRING).
• The control panel will default
to setting 1. To determine
the setting for your water
feature without using the
Smart Control App, use the
QR code (Ex. 14) or locate
the QR code on your water
treatment to access the XT
setting selector.
• Once setting is determined
use the + and - buttons on
the control panel to set to recommended setting.
APP PAIRING
• Make controlling and monitoring the XT system easy by
connecting the control panel to the Aquascape Smart
Control App.
NOTE: Adequate Wi-Fi Coverage is required (2.4 GHz
networks supported). A strong stable network will
prevent connection issues. For additional information visit
aquascapeinc.com/smart-control-app.
NOTE: The blinking blue light indicates the unit is in pairing
mode and ready to be connected.
• Download the Aquascape Smart
Control App (available on iOS or
Android App Store).
• Open the app and click 'Create New
Account' (Ex. 15).
NOTE: If you already have an account,
login with your username and
password.
aquascapeinc.com | CAN (866) 766-3426 |
☎
• Once logged in, click the three dashes in the upper, right-
hand corner of the home screen (Ex. 16).
• Click 'Add New Device' (Ex. 17).
• Continue to follow on-screen instructions to complete the
pairing process.
NOTE: To reset the device to factory defaults, press and
hold the + and - button for 5 seconds within 1 minute of
connecting the controller to power then release when the
Ex. 13
LCD screen shows 88.
PRIMING PROCEDURE
• When first setting up the system or when adding a new
water treatment bottle, the system should be primed to
push the treatment through the output tubing.
• The priming process can be completed in the Smart
Control App or manually. To manually enter the priming
mode, hold the x2 button for 3 seconds until blue light
above the x2 button begins to flash. The priming mode will
automatically turn off after approximately three minutes,
returning to normal operation. The priming mode can be
exited at any time by pressing the x2 button when the
treatment begins to discharge at the end of the tubing.
LOW-TREATMENT ALERT
Ex. 14
• The system is equipped with a convenient low-treatment
alert which uses an electromagnetic switch on the intake
assembly to notify you when a treatment bottle is 90%
empty, ensuring you can replace the treatment before it
runs out.
• When 90% empty, the Low-Treatment Alert LED on the
control panel will illuminate (Ex. 18).
• Pair the control panel to the Aquascape Smart Control
App to receive low-treatment alerts on your smartphone or
tablet (Ex. 19).
Ex. 15
☎ US (866) 877-6637
Ex. 16
Ex. 18
Ex. 17
Ex. 19
5