Installation - AquaScape 40040 Manual

Installation

SETUP
• It is recommended to place the Smart Pond Dosing
System XT as close to the water feature as possible to
minimize the distance the treatment must travel.
NOTE: The XT system can be buried to conceal into the
landscape (Ex. 1). Do not bury so deep that it causes
issues with opening or closing the lid.
• Open the lid of the enclosure and connect the control
panel by sliding downward into the tracks on the lid (Ex. 2).
• Connect the power cable to the control panel (Ex. 3).
• Connect the outlet tubing from the control panel to the
closest port at the back of the enclosure (Ex. 4).
NOTE: Inlet and outlet
tubing can be determined by
referencing the indicators on
the pump cartridge (Ex. 5).
• Connect the inlet tubing to
the barb at the top of the
intake assembly (Ex. 6). Then
connect the low-treatment
power cable to the control
panel (Ex. 7).
4
Ex. 1
Ex. 3
Ex. 6
• Set the selected water treatment bottle into the system as
shown. Insert the intake assembly into the top of the water
treatment bottle until sealed at the top (Ex. 8).
NOTE: The XT system is designed and calibrated for use
only with Aquascape Simple Solution XT water treatments,
available in both half and full gallon bottles.
• Attach the discharge tubing to the proper fitting at the
back of the control panel (Ex. 9).
Ex. 2
• Position the opposite end of the discharge tubing where
you intend to add the treatment into the water feature.
Treatment can be dispensed directly into the pond or
fountain or into a skimmer or pump vault (Ex. 10).
NOTE: Position discharge tubing above water level.
• Attach the transformer to the dosing system power cord
using the quick-connect fitting at the end of the cable (Ex. 11).
NOTE: The unit can also be powered by an existing 12V
outdoor transformer. Each Smart Controller uses 6 watts.
Directly into Skimmer
or Waterfall Vault
Ex. 4
• Plug the transformer into a GFCI-rated receptacle.
NOTE: the unit may run once it receives power.
Ex. 5
• If desired, the XT system allows you to add multiple
treatments simultaneously using a Controller Add-On Kit
(Item #40042). This will allow you to add two half gallon
treatments simultaneously (i.e. Maintain and Clear).
Ex. 7
US (866) 877-6637 |
☎ ☎
Ex. 8
Ex. 10
CAN (866) 766-3426 | aquascapeinc.com
Ex. 9
Ex. 11