Advertisement
ENGLISH
10
Replacing the rechargeable battery
Replace the rechargeable battery when you can no longer recharge it or when it runs out of power
quickly. You can order a new rechargeable battery under order number CP0111 for FC8710 and
order number CP0110 for FC8700.
1
Let the robot run until the rechargeable battery is empty to make sure that the rechargeable
battery is completely discharged before you remove it and dispose of it.
2
Undo the screws of the battery cavity cover (Fig. 30).
3
Remove the battery cavity cover (Fig. 31).
4
Place the new rechargeable battery in the battery cavity, put back the battery cavity cover
and tighten the screws (Fig. 32).
Note: Make sure that the print on the battery points upwards and that the connectors point in
the right direction.
5
Place the battery cavity cover back onto the robot and fasten it with the screws.
Troubleshooting
This chapter summarises the most common problems you could encounter with this appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The robot does
not start cleaning
when I press the
on/off button.
The warning
indicator flashes
quickly.
Cause
The rechargeable battery
is empty.
The small plug is still
inserted in the socket on
the robot.
One or both wheels are
stuck.
One or both side brushes
are stuck.
The top cover is not
present or is not closed
properly.
The bumper is stuck.
The robot was lifted while
it was cleaning.
Solution
Charge the rechargeable battery (see chapter
'Preparing for use').
The robot does not work on mains power. It
only works on its rechargeable battery.
Therefore, always disconnect the adapter from
the robot and the mains before use.
Set the power switch to 'off '. Remove the fluff,
hair, thread or wire that is caught around the
wheel suspension.
Clean the side brushes (see chapter 'Cleaning
and maintenance').
When the top cover is not present or is not
closed properly, the robot does not work.
Place the top cover on the robot properly.
Press the on/off button. Lift the robot so that its
bumper comes free. Place the robot at some
distance from the obstacle and press the on/off
button to make it resume cleaning.
Press the on/off button. Place the robot on the
floor. Then press the on/off button to make the
robot resume cleaning.
Advertisement
