Gas Requirements; Electrical Requirements; Prepare Installation Space; Installation Dimensions - Bosch NGM8048UC Installation Instructions Manual

Hide thumbs Also See for NGM8048UC:
Table of Contents

Advertisement

Available languages

Available languages

en-us Prepare installation space
¡ Solid surface or laminate countertops often require spe-
cial installations. For example, heat-reflective tape and
rounded corners may be necessary. Contact the coun-
tertop manufacturer for instructions specific to your
countertop.
2.6 Gas requirements
Ensure that the requirements for the gas supply are met.
The cooktop is shipped from the factory for use with natu-
ral gas. For use with LP conversion, a certified technician
or installer must do the conversion.
Supply pressure:
¡ Natural Gas: 7 inches water column (17.4 Millibars)
¡ Propane Gas: 11 inches water column (27.4 Millibars)
¡ The propane gas tank must be equipped with its own
high pressure regulator in addition to the pressure regu-
lator supplied with this unit.
2.7 Electrical requirements
Ensure that the following electrical requirements are met.
CAUTION
Do not use an extension cord with this appliance.
¡ This appliance requires a 60 Hz, 15 Amp, 120 V/AC
connection.
¡ The appliance is equipped with a 40" (1000 mm) power
cord.
3.1 Installation dimensions
NGM8048UC
A
28¹⁵⁄₁₆" (735 mm)
B
7¼" (184 mm)
8
¡ The power connection must remain accessible from the
front of the cabinet after the installation is complete.
3 Prepare installation space

Prepare installation space

Create the cutout in the countertop according to the in-
Prepare installation space
structions.
General countertop requirements:
¡ The angle of the cut surface to the countertop surface
must be 90°.
¡ With multi-layered countertops, secure strips laterally in
the cutout if necessary.
¡ After creating the cutout, remove all debris.
¡ Follow the countertop manufacturer's recommendations
for protecting the cut edges, e.g. apply heat resistant foil
tape.
¡ If the cooktop will be installed in combination with an
oven, refer to the Approved Combination Matrix in-
cluded with the product for cutout and clearance dimen-
sions.
WARNING
The bottom of the cooktop can become hot.
If the cooktop is not installed in combination with an
oven, install a horizontal panel below the cooktop to
prevent accidental contact. Refer to the section on in-
stalling a horizontal panel. →  Page 9
*For installation in a kitchen island.
NGM8648UC
34¹⁵⁄₁₆" (887 mm)
10¼" (260 mm)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ngm8648uc

Table of Contents