Manfrotto MVG300XM Instructions Manual page 5

6.1 Balancing the tilt axis
6.1.1 Adjusting sliding arm
① Unlock the tilt axis, turn the camera lens upwards.
② Unscrew the sliding arm screw.
③ Slide vertical arm to balance it until the camera stays there at any angle,
balance successful.
④ Tighten the sliding arm screw.
2
6.1.2 Adjusting the quick release plate
① Push the camera lens forward, unlock the quick release plate safety lock.
② Move the quick release plate to the camera balncing position.
③ Lock the quick release plate with fixed plate safety lock.
2
3
4
3
1
1
6.2 Balancing roll axis
① Unlock Roll axis motor lock.
② Unscrew the cross arm screw.
③ Move the cross arm to balancing status.
④ Tighten cross arm screw.
2 4
3
1
6.3 Balancing pan axis
① Unlock pan axis motor lock
② Hold the handle and slant it(＞15°), put the vertical arm horizontally, unscrew
the vertical arm screw
③ Move the vertical arm to balancing status
④ Tighten vertical arm screw.
1
5
Use the memory red dot to
mark the balancing position