Seiko Astron 5X53 Complete User Manual page 53

7
TROUBLESHOOTING
Troubleshooting
Misalignment of After the reception is successful, the
date time is correct but the date is incorrect.
After the reception is successful, the
The sub-dial
basic time is correct but the time zone
cannot be
selected on the sub-dial is not
adjusted.
displayed.
The position of the hand showing the
Indicator hand reception way, charging status, in-
misalignment flight mode ( ), and DST is
misaligned
The crown or buttons cannot be
operated.
Operation
You get lost in the middle of the
operation.
Other trouble Blur in the display persists.
Possible causes
The preliminary position of the date is out of alignment.
This problem occurs when the preliminary position of the date is out of
alignment due to external influence etc.
The preliminary position of the sub-dial is out of alignment.
This problem occurs when the preliminary position of the sub-dial is out of
alignment due to external influence etc.
The automatic leap second reception function has been
activated, and the indicator hand indicates the "LEAP
SEC."
The preliminary position of the indicator hand is misaligned.
This occurs when the preliminary position of the indicator hand is misaligned
due to external factors.
The stored electric power is running short.
Date is moving right after a setting is carried out by the crown or button
operation.
-
A small amount of water has got inside the watch due to deterioration of the
gasket, etc.
ASTRON 5X53 GPS SOLAR
Adjust the preliminary position of the day hand (a day of week) to the correct position
"SUN (Sunday)."
Correctly adjust the sub-dial and the AM/PM hand to the preliminary position of
"12:00 AM".
It takes up to 18 minutes to complete the leap second reception.
Use the watch with reference to the P. 16.
Adjust the preliminary position of the indicator hand to the correct position "full."
Sufficiently charge the watch until it starts moving at 1-small second intervals.
Wait without doing anything. After the date stops, the crown and buttons can be operated.
When the crown is pulled out
① Push the crown back in.
② The seconds hand will start to move within 6 minutes.
③ After that, restart operation.
When the crown is not pulled out
① Press Button B.
② The seconds hand will start to move within 2 minutes.
③ After that, restart operation.
Consult the retailer from whom the watch was purchased.
52
Solutions Reference pages
P. 46 - 48
P. 46 - 48
P. 31
P. 46 - 48
P. 14
-
-
-
-