In Case Of An Unusual Movement Of The Seconds Hand; Seconds Hand Movement And Watch State (Energy Depletion Forewarning Function) - Seiko Astron 5X53 Complete User Manual

5

IN CASE OF AN UNUSUAL MOVEMENT OF THE SECONDS HAND

Seconds hand movement and watch state (energy depletion forewarning function)

Movement of the seconds hand shows the state of the watch (working functions).
2-second interval movement/5-second interval movement are brought
about
When the energy stored in the watch runs low, the energy depletion forewarning function
will work.
When the energy stored in the watch runs low, charge the watch by expose to light.→ How
to charge the watch P. 14
* When the energy depletion forewarning function works, the watch does not operate even with operation of the
buttons and crown.
(Be assured that it does not mean a failure)
2-second interval movement
The seconds hand moves at 2-second
intervals.
State
• Reception is not started even with
Restriction on
operation of GPS signal reception.
function/display
• Automatic time adjustment does not work.
① First, charge the watch by expose to light
until the seconds hand moves at 1-second
intervals.
→ How to charge the watch
② Keep in mind to charge the watch until the
Solution
indicator hand points to the "middle"
position or "full" position. (If the indicator
hand points to low position, GPS signals
cannot be received.)
→ Check the charging status
5-second interval movement
The seconds hand moves at 5-second
intervals.
• The hour hand, minute hand, date, day,
and sub-dial stop.
• Reception is not started even with
operation of GPS signal reception.
• Automatic time adjustment does not work.
① Charge the watch until the indicator hand
points to the "middle" position or "full"
P. 14
position.
→ Check the charging status P. 13
② Carry out time zone adjustment to set the
time.
→ How to adjust the time zone P. 20
P. 13
ASTRON 5X53 GPS SOLAR
The seconds hand stops at the 15-second position/45-second position
(Power save function)
When the watch is not exposed to light for a long time, the power save function will work.
Power Save 1
The seconds hand stops pointing at the 15-second
position.
State
• The hour hand, minute hand, date, day, and
Restriction on
sub-dial stop.
function/display
• Automatic time adjustment is not performed.
When the watch is exposed to a state without
Cause receiving an adequate light source for 72 hours or
longer.
• When the watch is exposed to an adequate light
source for more than 5 seconds, or when any
Solution
button is pressed, it displays the current time
again after the seconds hand is rapidly
advanced.
Power Save 2
* While the watch is being charged, the seconds hand moves at "5-second intervals." During the "5-second Interval
Movement," the buttons cannot be operated.
* If the " Power Save 2" mode is prolonged, the stored power amount drops and the internal current time information
stored will be lost.
33
Power Save 2
The seconds hand stops pointing at the 45-second
position.
• The hour hand, minute hand, date, day hand,
and sub-dial stop (the date displays "1", day
hand displays "SUN" (Sunday), and sub-dial
displays 12:00 AM).
• Reception is not started even with operation of
GPS signal reception.
• Automatic time adjustment is not performed.
• The indicator hand points to low position.
When the watch is in an insufficient charging state
for a long time.
① Charge the watch until the indicator hand points
to the "middle" position or "full" position.
→ Check the charging status P. 13
② Adjust the preliminary position for each hand.
→ Adjust the preliminary position of the sub-
dial, day hand, date, indicator hand, and
hour/minute hands P. 46
③ Carry out time zone adjustment to set the time.
→ How to adjust the time zone P. 20