Resetting The System; Default System Settings - Pioneer VSX-1121-K Operating Instructions Manual

Resetting the system

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this. Set MULTI-ZONE to
MULTI ZONE OFF.
! Disconnect the iPod and USB memory device
from the receiver beforehand.
! Set the Control with HDMI to OFF (see HDMI
Setup on page 45 ).
1 Switch the receiver into standby.
2 While holding down ENTER on the
front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select 'RESET' using PRESET k/l,
then press ENTER on the front panel.
The display shows RESET? OK.
4 Press ENTER to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
! Note that all settings will be saved, even if the
receiver is unplugged.

Default system settings

Setting Default
Digital Video Converter ON
SPEAKERS SB/FH
Normal
Speaker System
(SB/FH)
Front SMALL
Center SMALL
FH/FW SMALL
Speaker Setting
Surr SMALL
SB SMALLx2
SW YES
Surround Position IN REAR
Crossover 80 Hz
X-Curve OFF
DIMMER Brightest
Inputs
See Input function default and possible settings on
page 27 .
HDMI
HDMI Audio Amp
Control ON
Control Mode PQLS
Display Power Off NO
Audio playback
Power On Level LAST
Volume Limit OFF
Mute Level FULL
Phase Control ON
iPod/USB,
HOME MEDIA
GALLERY, ON
Auto Sound
ADAPTER PORT
Retriever
input function
Other input
OFF
functions
Sound Delay 0.0 frame
Dual Mono CH1
Setting Default
DRC AUTO
SACD Gain 0 dB
LFE Attenuate 0 dB
Auto delay OFF
Digital Safety OFF
ExtendedStereo 90
Effect Level
Other modes 50
Center Width 3
2 PL II Music
Dimension 0
Options
Panorama OFF
Neo:6
CINEMA: 10
Neo:6 Options Center Image
Neo:6
MUSIC: 3
2 PL IIz Options Height Gain MID
Listening Mode AUTO
(2 ch/multi ch) SURROUND
All Inputs
Listening Mode
STEREO
(Headphones)
See also Setting the Audio options on page 48 for
other default DSP settings.
MCACC
M1:
MCACC Position Memory
MEMORY 1
Channel Level (M1 to M6) 0.0 dB
Speaker Distance (M1 to M6) 10'00''
ATT of all
0.0 dB
Standing Wave
channels/filters
(M1 to M6)
SWch Wide Trim 0.0 dB
All channels/
0.0 dB
EQ Data (M1
bands
to M6)
EQ Wide Trim 0.0 dB
Using other functions 09
53
En