Table of Contents
Advertisement
Pass mode
In this mode, the shaft supporting the laser is rotated so that the laser beam strikes the sensor
lens as it passes it. Measurements are taken when the laser beam passes through the middle
sector of the detector.
Center the laser beam. A pulsating M (1) indicates that measurement may be taken.
l
Tap M or
l
Rotate the shaft supporting one of the measurement heads (say laser) to the next pos-
l
ition, then rotate the shaft supporting the other head (say sensor) slowly past the oppos-
ite head. Measurement is automatically taken as the laser beam strikes and passes the
sensor detector.
Note
ROTALIGN touch EX
to take initial measurement point.
On-board help
55
Advertisement
Table of Contents
