Table of Contents
Advertisement
Live Move – machine train alignment
Decide which pair of machines to move in a train, one may need to re-install and re-adjust the
laser and sensor across the chosen coupling. Be sure to install the sensor at exactly the same
location on the shaft or coupling as previously, or re-enter the new correct distance from the
sensor to the coupling. In the following example, the chosen machine pair is pump (left
machine) and gearbox (right machine) as shown by the highlighting window on the mini train
inset (1).
Tap
to start Live Move. If all machines are designated movable, then the "Fixed feet"
screen for the selected coupling position appears.
Note
The grayed out machine indicates that the measurement focus (see mini train inset [1]
is NOT on the coupling next to this particular machine but to the coupling connecting the
other two machines.
Tap feet on the machine train to be designated stationary then tap
Live Move.
ROTALIGN touch EX
On-board help
to proceed with
127
Advertisement
Table of Contents
