Honda HRX476XB Owner's Manual page 6

INSTALLATION AND REMOVAL OF THE BATTERY
PACK
Do not handle with wet hand, or under rain condition.
CAUTION:
• When you close the battery cover, please pay attention to avoid
pinching your finger by battery cover.
• For each action, pay attention not to be injured.
• Always use Honda battery pack.
Installation:
1. Turn the isolator key [1] to OFF (0) position [2] and remove the
key from the motor.
[2]
2. Push the battery cover opening lever [3] to open the battery
cover [4].
[4]
3. Ensure that the battery pack attaching area is clean. Install the
battery pack [5] to the terminal [6]. Push the battery pack until
you hear clicking sound.
[5]
4. Close the battery cover securely.
NOTE:
Whenever you open the cover, always confirm that the battery is
well connected before closing it.
6 EN
Removal:
1. Turn the isolator key to OFF (0) position and remove the key
from the motor.
2. Push the battery cover opening lever to open the battery cover.
When the cover is opened, the battery pack comes off from
the terminal simultaneously.
3. Pick up the battery pack.
4. Close the battery cover securely.
CHECKING BATTERY LEVEL
Battery level can be confirmed with the battery indicator [1] of the
handle.
1. Install the battery pack to the machine.
2. Insert the isolator key to the motor and turn the key to ON (I)
position [2].
3. Press the yellow button [3], then the battery indicator will come
on.
[1]
4. Remaining battery capacity is displayed in 3 levels.
LEDs behavior of battery indicator
[3]
- LEDs show battery pack and machine status.
- When the battery is installed and isolator key is on, the LEDs
- LEDs light for approximately 48 seconds.
- While the machine is running, LEDs do not light.
LEDs show machine or battery pack condition as following.
1 LED on
0% < state of charge ≤ 30%
2 LED on
30% < state of charge ≤ 60%
3 LED on
60% < state of charge ≤ 100%
[6]
Blinking 1 LED
State of charge 0% = Empty
Blinking 3 LED
Motor shut off due to motor
overheating or battery pack
overheating.
Turn the isolator key to OFF (0) and
let the machine cool down for 10 to
20 minutes.
Charge the battery pack if the battery level is low.
See annexed instructions for battery pack and charger.
CHARGING THE BATTERY PACK
See owners manual for battery pack and charger.
will come on by operating the yellow button or cutting-means
control lever.
[2]
[3]
[1]