Ikan PT4900-SDI-TK Quick Start Manual page 3

Teleprompter Assembly Setup
Step 1
Place the Hood Attachment Frame over the Glass Holder. Then place the
glass against the Glass Holder. Make sure the screws pass through the
holes on the both the Hood Attachment Frame and the Glass Holder.
Step 3
Remove the monitor mounts from the teleprompter base using
the included larger 4mm hex key to loosen from the 15mm rods.
www.ikancorp.com | 1.713.272.8822 | sales@ikancorp.com
Step 2
Secure the Glass Holder by fastening the knurled nuts to the screws as
pictured below.
Step 4
Put the washers on before tightening the screws. The washers and 4
additional screws are inside a bag on the bottom foam.