Compatible Consoles; Related Manuals; Contractor Certification Requirements - Veeder-Root Overfill Alarm Installation Manual

Introduction
This manual contains installation procedures for the Veeder-Root Overfill Alarm and Acknowledgment (Ack)
Switch.
The Overfill Alarm unit contains:
• Red flashing light
• Alarm horn
The Acknowledgment Switch unit contains:
• ACKNOWLEGED light
• RESET push button
• TEST push button

Compatible Consoles

• TLS-3XX/4XX Series
• TLS-IB
• TLS-50
• TLS-HLD
• TLS2

Related Manuals

Depending on your installed console, you should reference the appropriate manuals below, to connect/setup the
Overfill Alarm:
576013-879 TLS-3XX Series Site Prep Manual
577013-608 TLS-50 Site Prep manual
577013-756 TLS2 Site Prep manual
577013-719 TLS-IB Site Prep manual
577013-784 TLS-HLD Site Prep manual

Contractor Certification Requirements

Veeder-Root requires the following minimum training certifications for contractors who will install and setup the
equipment discussed in this manual:
Service Technician Certification (Previously known as Level 2/3): Contractors holding valid Technician
Certifications are approved to perform installation checkout, startup, programming and operations training, system
tests, troubleshooting and servicing for all Veeder-Root Series Tank Monitoring Systems, including Line Leak
Detection.
TLS-3xx Technician Certification: Contractors holding valid TLS-350 Technician Certifications are approved to
perform installation checkout, startup, programming and operations training, troubleshooting and servicing for all
Veeder-Root TLS-300 or TLS-350 Series Tank Monitoring Systems, including Line Leak Detection and associated
accessories.
576013-623 TLS-3XX Series Setup manual
577013-609 TLS-50 Setup manual
577013-757 TLS2 Setup manual
577013-785 TLS-HLD Setup manual
577013-879 TLS-4XX Site Prep Manual
1