Table of Contents
Advertisement
• Don't place blade assembly onto the
housing base without the jar attached.
• Make sure blade assembly is tightly attached
to jar.
• Always remove blade assembly before
cleaning.
• Don't twist blade assembly from blender jar
when removing from the Food Processor
housing base. Simply lift jar from the Food
Processor housing base.
• Use a plastic spatula as needed, only when the
unit is not plugged in. Do not use any utensil
inside the blender while motor is on.
• Never use metal utensils, as damage may
occur to the jar or blade assembly.
• Don't store food or liquids in your blender jar.
• Don't overload blender jar. If the motor stalls,
turn the blender off immediately, unplug the
unit and let it cool for at least 15 minutes. Then
remove a portion of the food and continue.
TROUBLESHOOTING
PROBLEM:
Unit is not turning on.
The blending process stopped.
The rubber gasket won't come off of
the blade assembly for cleaning.
Blender jar appears to be leaking.
• CAUTION: NEVER use carbonated beverages
in the blender jar.
• Don't blend boiling liquids in blender jar.
• Don't use any container or accessories not
recommended by Cuisinart. Doing so may
result in injury.
• To remove blender jar from the housing
base, turn counterclockwise using the blender
jar handle.
• The blender jar is not recommended for
microwave use.
SOLUTION:
Be sure the blender jar assembly is correctly attached to the Food Processor
housing base.
1. Plug the housing base into an independent outlet.
2. Make sure the Food Processor housing base is securely plugged in.
3. Check the outlet for power; try plugging into a different outlet.
4. Check your home's circuit breaker.
5. Make sure the interlocking cover is fitted correctly on the jar.
The Food Processor housing base motor could have overheated. The
resettable fuse, which protects the motor, may have been tripped due to
overloading. If this happens, reset the appliance by unplugging the unit and
allowing it to cool for a minimum of 15 minutes. Then reduce the contents of
the blender jar and/or clear any jams. Restart the unit as noted in the
operating directions.
Run blade assembly under water and tap on the edge of sink upside down to
loosen the gasket. Avoid hitting the blades, which could cause damage.
1. Check rubber gasket. Make sure it's flush with blender assembly.
2. Make sure rubber gasket is properly in place.
3. Make sure rubber gasket is not damaged.
4. Make sure jar blade assembly is tight.
5
Advertisement
Table of Contents
