Cleaning And Maintenance; Troubleshooting - Cuisinart SmartPower CPB-300 Instruction And Recipe Booklet

CLeanIng and maIntenanCe

Always unplug your Cuisinart ®
from the electrical outlet before cleaning. The base and parts are made of
corrosion-resistant materials that are easy to clean. Before first use and
after every use, clean each part thoroughly. Periodically check all parts
before reassembly. DO NOT USE if any part is damaged, or if the jar or
cups are chipped or cracked.
To remove blade assemblies, twist off by turning counterclockwise.
NEVER TOUCH THE BLADE ITSELF.
CAUTION: Handle the blade assemblies carefully. They are SHARP and
may cause injury. DO NOT attempt to remove blades from cutting assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly. All parts are
top rack dishwasher safe.
Tip: You may wish to clean your blending and chopper cutting assemblies
as follows: squirt a small amount of dishwashing liquid into blender jar or
cups and fill halfway with warm water. Attach blade assembly. Run on Low
for 15 seconds. Repeat, using clean tap water. Carefully disassemble parts
and empty blender jar or cups. Rinse and dry all parts thoroughly.
Finally, wipe the motor base clean with a damp cloth to remove any residue,
and dry thoroughly. Never submerge the motor base in water or other
liquids, or place in a dishwasher.
Any other servicing should be performed by an authorized service
representative.
SmartPower ® Portable Compact Blender

TROUBLESHOOTING

Problem:
Be sure the blade assembly is on the jar or cup correctly.
Be sure it is pushed all the way onto the base. A red light
should come on and the unit should be in Standby mode.
My blender is not turning 1. Plug blender into an independent outlet.
on or going into Standby 2. Make sure blender is securely plugged in.
mode?
3. Check the outlet for power; try plugging into a different
4. Check your home's circuit breaker.
The motor could have overheated. The resettable fuse,
which protects the motor due to overloading, may have
been tripped. When this happens, to reset the appliance
The blender stopped
unplug the unit and let it cool for a minimum of 15 minutes.
running.
Then, reduce the contents of the blender jar and/or clear
any jams. Restart the unit as noted in the operating
directions.
The rubber gasket won't
Run under water and tap on the edge of sink upside down
come out from the blade
to loosen the gasket.
assembly for cleaning.
The blade assembly is The ingredients cause pressure, and with the air tight seal,
hard to remove after pressure builds up creating a vacuum or a suction effect.
blending. This is normal.
1. Check rubber gasket. Make sure it's flush with blender
Unit appears to be leaking
2. Make sure rubber gasket is properly in place.
3. Make sure rubber gasket is not damaged.
6
Solution:
as stated on page 5.
outlet.
assembly.