Table of Contents
Advertisement
en Basic settings
Display
Basic setting
Interior lighting during operation
Cooling fan run-on time
Telescopic shelves retrofitted
Sabbath mode available
→ "Sabbath mode", Page 19
Water hardness
→ "Setting the water hardness", Page 20
Automatic rapid heating from 200 °C
Reset all values to factory settings
1
Factory setting (may vary according to model)
Depending on the appliance specifications
2
14.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold the
1.
four seconds.
a The first basic setting appears in the display,
e.g. .
Use the temperature selector to change the setting.
2.
Use the
or
button to switch to the next basic
3.
setting.
To save the changes, press and hold the
4.
for approx. four seconds.
Note: Your changes to the basic settings will be re-
tained even after a power failure.
14.3 Discarding changes to the basic
settings
Turn the function selector.
▶
a All changes are discarded and not saved.
14.4 Setting the water hardness
ATTENTION!
If the wrong water hardness has been set, the appli-
ance cannot remind you to descale it at the right time.
Set the water hardness correctly.
▶
Using unsuitable liquids may damage the appliance.
Do not use distilled water, highly chlorinated tap wa-
▶
ter (>40 mg/l) or other liquids.
Only use cold, fresh tap water, softened water or
▶
non-carbonated mineral water.
Requirements
¡ Before you set the water hardness, ask your water
supplier about the hardness of your tap water.
¡ The appliance must be switched off.
20
2
button for approximately
button
Selection
= no
1
= yes
= short
1
= medium
= long
= extra-long
1
= no
(for rails and 1-level pull-out)
= yes (for 2- and 3-level pull-out)
1
= no
= yes
= softened
= soft (up to 1.5 mmol/l)
= medium (1.5–2.5 mmol/l)
= hard (2.5–3.8 mmol/l)
= very hard (above 3.8 mmol/l)
2
= no
1
= yes
1
= no
= yes
Press and hold the
1.
four seconds.
a The first basic setting appears in the display,
e.g. .
Use the
2.
setting .
Use the temperature selector to set the water hard-
3.
ness.
Tip: If your tap water is very hard, we recommend
that you use softened water. If you use only
softened water, you can set your appliance to the
"softened" water hardness range.
Tip: If you use mineral water, set the water hardness
range to "very hard". If you use mineral water, you
must only use non-carbonated mineral water.
Water hardness
basic setting
=
softened
= soft
= medium
= hard
= very
2
hard
1
Only set this if you will be using solely softened
water.
Also set for mineral water. Only use non-carbon-
2
ated mineral water.
To save the changes, press and hold the
4.
for approx. four seconds.
1
button for approximately
or
button to switch to the next basic
Water
German
hardness
hardness
in mmol/l
in °dH
-
-
1
Up to 1.5 Up to 8.4 Up to 15
1.5-2.5
8.4-14
2.5-3.8
14-21.3
Above
Above
3.8
21.3
French
hardness
°fH
-
15-25
25-38
Above 38
button
Advertisement
Table of Contents
