Area Code; Flash Time; Dial Mode - Motorola C42 Manual

Note
When you are storing a phone number in the Block list, you will need to store
the full number including the dialing code for the number to be blocked.
If you want to change/delete the block number, follow the first 4 steps above.
Then scroll to the slot where the number is stored and press the left
Delete the number by pressing the right
to save no number or enter the new number. Press the left
12.2

Area code

The area code must be 3 digits long.
1. Press the left
2. Press the left
3. Press the left
4. Press the left
12.3

Flash time

Depending on your country and network operator, your phone has the flash
time set as long. It is unlikely that you need to change this setting unless
advised to do so.
1. Press the left
2. Press the left
3. Press the left
4. Press the left
12.4

Dial mode

Your phone is set to tone dialing. You should only need to change this if
connected to an older type of switchboard / PBX which requires pulse dialing.
1. Press the left
2. Press the left
3. Press the left
4. Press the left
12.5 Switch Auto clock on / off
If you have subscribed to Caller ID service, the date and time will be set on all
your handsets whenever a call is received. This feature can be set to On or Off.
1. Press the left
2. Press the left
3. Press the left
4. Press the left
Advanced settings
key, scroll to
O D
key, scroll to
O D
key, enter the area code.
O
key to confirm.
O
key, scroll to
O D
key, scroll to
O D
key, press or
O U
key to confirm.
O
key, scroll to
O D
key, scroll to
O D
key. Then press
O
key to confirm.
O
key, scroll to
O D
key, scroll to
O D
key, scroll to
O D
key to confirm.
O
key. Then either press the left
O
Advanced set.
Area code.
Advanced set.
Flash time.
100ms, 250ms
to select
D
Advanced set.
Dial mode.
Tone
or to select
U D
Advanced set.
Auto clock.
On or Off.
key.
O
O
key to save.
O
or 600ms.
or Pulse.
key
47