Drive Motor M16 Assembly - Ricoh CF5010 Service Manual

X03258 CF5010e Service manual

3.2.6 DRIVE MOTOR M16 ASSEMBLY

[B]
Removal
1. Remove complete Cover Feeder unit (
2. Disconnect Connector [A] (
3. Remove Drive motor M16 assembly by removing screws [B] (
NOTE: Be careful when removing the Drive motor M16 assembly, so that the
Drive Shaft Assembly will not damage the LED sensor CF-Q30 (
3.1.2).
4. Loosen the allen screw [C] to Drive clutch assembly (
5. Remove the motor bracket by removing screws [D] (
Replacement
1. Reverse the removal procedure.
2. Enter Service mode (
3. Perform Cover Feeder motor calibration (
al).
Adjustment
Adjust the Drive clutch assembly, so that there is play between the coupling on the
Drive shaft and the Clutch. The play should be 0.4 ± 0.3 mm. Adjust by loosening
screw [C].
[A]
1.1.1).
x1).
5.1.1 in BK5010e Service Manual).
0.4 ± 0.3 mm play between
the coupling and the clutch
CF-3-9
[C]
x2).
x1).
x3).
5.5 in BK5010e Service Manu-
15 Jan 2013
[D]
[C]