Canon EOS R10 User Manual page 96

FAQ
Focusing is not possible (indicated by an orange AF point).
Aim the AF point over an area with good contrast, then press the shutter button halfway
( ). If you are too close to the subject, move away and shoot again.
Multiple AF points are displayed simultaneously.
Focus has been achieved at all those points.
The shutter speed display is blinking.
Since it is too dark, taking the picture may result in a blurred subject due to camera
shake. Using a tripod, the built-in flash, or an external flash (
Pictures are too dark.
Raise the built-in flash in advance to enable automatic flash firing, in case subjects in
daytime shots are backlit, or when shooting under low light.
Pictures taken with flash are too bright.
Pictures may be bright (overexposed) if you shoot subjects at close range in flash
photography. Move away from the subject and shoot again.
The bottom part of pictures taken with flash is unnaturally dark.
Shooting subjects that are too close may make the shadow of the lens visible in your
shots. Move away from the subject and shoot again. If you are using a lens hood, try
removing it before shooting.
Note
Note the following if you are not using the built-in flash.
• Under low light, when camera shake tends to occur, hold the camera steady or
use a tripod. When using a zoom lens, you can reduce the blur caused by
camera shake by setting the lens to the wide-angle end.
• When shooting portraits under low light, tell subjects to stay still until you have
finished shooting. Any movement as you shoot will make the person look blurry
in the picture.
96
) is recommended.