Advertisement
Available languages
Available languages
D - MAINTENANCE AND SERVICING
CAUTIONS
• The plug must be removed from the socket outlet
before cleaning or maintaining the appliance.
• DO NOT use hot air or hot surface to dry fi lters. Dry
them at room temperature for approximately 24 hours.
• IMPORTANT: Before re-installing the washable fi lters,
make sure they are completely dry to avoid damaging
the appliance.
NOTE: If the cloth dust bag is not properly installed, the dust
cover will not close. Be sure to check that the cloth
dust bag is properly installed before operating the
appliance, otherwise dust will leak out.
The paper dust bag can easily lay on the dust cover
packing or clip between the bag collar and the body,
so be sure to properly extend it into the body of the
appliance.
Replacing the cloth dust bag
D-1
Lift the dust cover catch and raise the dust cover until
it clicks properly.
D-2
Remove the bag collar from the bag holder and pull
out the cloth dust bag.
D-3
Put in a new cloth dust bag.
D-4
Close the dust cover properly until you hear it click.
When using a cloth bag
D-5
Slide the bag clip to open the dust bag, pour out the
dirt, then slide the bag clip back to its original position.
(Please don't throw away the bag clip.)
D-6
Next slide the bag collar back into the bag holder with
holding the bag collar and the bag clip together so
that the bag clip will fi t into the space.
Floor nozzle
D-7
Inspect once a month.
Using an old toothbrush or similar tool, clean any dirt
or lint from the brush.
Vacuum cleaner body
D-8
Wipe with a soft cloth soaked with water.
Maintaining the Pre-motor Filter
Follow the procedure written below when the suction power
is not restored after replacing a new paper dust bag.
D-9
Open the dust cover.
D-10 Remove the pre-motor fi lter.
D-11 Wash gently with water and then allow to dry in a
shaded location.
D-12 Return the pre-motor fi lter to its original position.
NOTE: Make sure you remember to replace the fi lter.
If the fi lter is not installed, it will cause motor
failure.
• Do not wash the fi lter in a washing machine or dry it
with a dryer or other source of hot air.
What to do if your cleaner does not work
Check that the appliance is correctly plugged in and that the
socket outlet is working. If the thermal cut-out device has
operated, wait until it resets automatically after approximately 60
minutes.
If after having checked the above mentioned points, the
appliance does not work, take it to an Authorized Service Centre
to be repaired.
What to do when the suction performance
reduces
• Stop the appliance and unplug from the socket outlet.
• Check whether the wands, hose and accessories are blocked or
not. If they are blocked, remove the obstruction.
• Check whether the cloth dust bag is full. If it is full, replace it.
• Check whether the pre-motor fi lter is blocked with dust.
If they are blocked, clean them out or replace them.
SPECIFICATIONS
Power source
Max. Input
Nominal input
Dimensions (W x L x H)
Net weight
Extension wands
Multipurpose accessory
REMINDER FOR CUSTOMER
The model and serial number of this product may be found on
the nameplate located on the underside of your appliance. You
should note the model and serial number in the spaces provided
and retain this book as a permanent record of your purchase.
Model Number. .............................................................................
Serial No. ......................................................................................
Date Purchased. ...........................................................................
Where Purchased. ........................................................................
5
MC-CG383
MC-CG381
220 V~50 Hz
1800 W
1600 W
1500 W
1300 W
240 mm x 350 mm x 250 mm
3.8 kg
Plastic telescopic
√
Advertisement
