Panasonic MicroClear4000 Operating Instructions Manual page 20

Replacing the Cartridge
How to replace the cartridge
⿟Before replacing the cartridge, turn off the faucet. Do not run water through with the cartridge
removed. (Doing so will cause the water to overflow.)
1
Remove the old cartridge.
⿟Remove the cartridge in the sink.
(Water will drip)
① Turn the cartridge to the direction
indicated by the arrow.
② Remove.
Old cartridge
①
EN38
TK-CJ600_CJ300_EXZ.indb 38-39
(continued)
2
Install the new cartridge.
① Mark the month when the cartridge was
replaced using a permanent marker.
E.g.: Replaced in March
②
⿟Dispose of the used cartridge in accordance with the applicable ordinances in the area concerned.
(The material of the cartridge cover is ABS. Refer to "Filter material" in "Specifications" for the type
of the filter materials (P. EN49).)
② Align the mounting position and push in
cartridge to the direction indicated by the
arrow.
⿟Align the tab position and size.
③ Slowly turn it in the direction of the arrow
until it stops.
⿟Do not over-tighten the cartridge.
(Doing so may damage the cartridge
mount and cause water to leak.)
Proceed to Step 3
on the next page
EN39
2022/01/05 15:32:29