Advertisement
Available languages
Available languages
5
ONE-TOUCH
Press the "ONE-TOUCH" button for fully automated operation that is
customized to the typical consumer preferences in your region of the world.
The customized settings control temperature air fl ow strength, air fl ow
direction and other settings to provide you alternate contact with "ONE-
TOUCH" of the button. If you prefer other settings you can select from the
many other operating functions of your Toshiba unit.
ONE-TOUCH
Press
: Start the operation.
6
AUTOMATIC OPERATION
To automatically select cooling or fan only operation
MODE
1. Press
: Select A.
2. Press
: Set the desired temperature.
FAN
3. Press
: Select AUTO, LOW , LOW+
MED+
, or HIGH
.
7
COOLING / FAN ONLY OPERATION
MODE
1. Press
: Select Cool
or Fan only
2. Press
: Set the desired temperature.
Cooling: Min. 17°C, Fan Only: No temperature indication
FAN
3. Press
: Select AUTO, LOW , LOW+
MED+
, or HIGH
.
8
DRY OPERATION
For dehumidifi cation, a moderate cooling performance is controlled automatically.
MODE
1. Press
: Select Dry
.
2. Press
: Set the desired temperature.
9
Hi-POWER OPERATION
To automatically control room temperature and airfl ow for faster cooling
operation (except in DRY and FAN ONLY mode)
Hi POWER
Press
: Start and stop the operation.
10
POWER-SELECTION OPERATION
This function is used when its circuit breaker is shared with other electrical
appliances. It limits the maximum current/power consumption to 100%, 75%
or 50%. The lower the percentage, the higher the saving and also the longer
the compressor lifetime.
POWER-SEL
Press
: Select
(for 100%),
●
When the level is selected, PWR-SEL level flashes on LCD display for 3
seconds. In case of 75% and 50% level, number "75" or "50" also flashes
for 2 seconds.
●
Due to the reason that POWER SELECT FUNCTION limits the maximum
current, inadequate cooling capacity may occur.
11
TEMPORARY OPERATION
In case of the misplaced or discharged remote control
●
Pressing the RESET button, the unit can start or
stop without using the remote control.
●
Operation mode is set on AUTOMATIC operation,
preset temperature is 24°C and fan operation is
automatic speed.
12
TIMER OPERATION
Set the timer when the air conditioner is operating.
1
2
3
Daily timer allows the user to set both the ON & OFF timers and will be
activated on a daily basis.
Setting Daily Timer
1
2
, MED
,
●
During the daily timer is activating, both arrows ( , ) are indicated.
Note:
●
Keep the remote control in accessible transmission to the indoor unit;
otherwise, the time lag of up to 15 minutes will occur.
●
The setting will be saved for the next same operation.
.
13
PRESET OPERATION
Set your preferred operation for future use. The setting will be memorized by
the unit for future operation (except airfl ow direction).
, MED
,
1. Select your preferred operation.
2. Press and hold
The P mark displays.
3. Press
14
AUTO RESTART OPERATION
To automatically restart the air conditioner after the power failure (Power of
the unit must be on.)
Setting
1. Press and hold the RESET button on the indoor unit for 3 seconds to set
the operation. (3 beep sound and OPERATION lamp blink 5 time/sec for
5 seconds)
2. Press and hold the RESET button on the indoor unit for 3 seconds to
cancel the operation. (3 beep sound but OPERATION lamp does not
blink)
●
15
QUIET OPERATION
To operate at super low fan speed for quiet operation (except in DRY mode)
Press
Note: Under certain conditions, QUIET operation may not provide adequate
(for 75%),
(for 50%)
COMFORT SLEEP OPERATION
16
For comfortable sleep, automatically control air fl ow and automatically turn OFF.
Press
Note: The cooling operation, the set temperature will increase automatically
17
MAINTENANCE
Firstly, turn off the circuit breaker.
Indoor Unit and Remote Control
●
Clean the indoor unit and the remote control with a wet cloth when needed.
●
No benzine, thinner, polishing powder or chemically-treated duster.
Air fi lters
Clean every 2 weeks.
1. Open the air inlet grille.
2. Remove the air fi lter.
3. Vacuum or wash and then dry them.
4. Reinstall the air fi lters and close the air inlet grille.
Setting the ON Timer
Setting the OFF Timer
Press
Press
: Set the desired
ON timer.
Press
: Set the timer.
Press
Press
: Cancel the timer.
Press
3
Press
Press
: Set the ON timer.
Press
4
Press
: Set the OFF timer.
the ( or ) mark fl ashing.
for 3 seconds to memorize the setting.
: Operate the preset operation.
In case of ON timer or OFF timer are set, AUTO RESTART OPERATION
does not activate.
QUIET
: Start and stop the operation.
cooling due to low sound features.
: Select 1, 3, 5 or 9 hrs for OFF timer operation.
1 degree/hour for 2 hours (maximum 2 degrees increase).
: Set the desired
OFF timer.
: Set the timer.
: Cancel the timer.
EN
CT
.
button during
Advertisement
