Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for CORNING 315
Summary of Contents for CORNING 315
-
Page 2: Program Menu
0 = no reminder). When the selected measurement endpoint on/off time has elapsed the calibration reminder symbol will appear. The 315 has a preset starts calibration recalls last cal data reminder interval of 1. Change the for current mode... -
Page 3: Buffer Tables
‘tenths’ digit point calibrations, do not select a slope as until the display shows 0.500, then press the 315 will calculate the slope and use this mode to confirm. The ‘hundredths’ digit value rather than the factory setting. -
Page 4: Measuring Samples
When you press cal the pH buffer or concentration standard you selected for cal 1 (Program Menu) is displayed for 2 seconds, and then the 315 starts measuring. If you want to use another pH buffer (choice of 3) or conc. standard (choice of 5) press cal again. -
Page 5: Maintenance
476613 Epoxy, 3-in-1 Polymer Gel Electrode (4' cable) Entered temperature value changes to –5.0 or 476614 Epoxy, 3-in-1 Refillable Electrode (4' cable) 130.0 - the 315 will not accept values outside this 477269 Replaceable Junctions 3/pk range. 470444 Rubber Meter Holder and Neck Strap... -
Page 6: Using Continuous Measurement Mode
Concentration - Output depends on valency and charge of ionic species being measured, and is In normal mode, the 315 will auto-off 10 minutes typically approximately ± 60 or ± 30 mV/decade. after the last key press, whether the unit is Recorder output is not available for temperature.
Need help?
Do you have a question about the 315 and is the answer not in the manual?
Questions and answers