Major Operating Controls And Their Functions; Top (Control Panel) - Panasonic AW-SW350E Operating Instructions Manual

MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS

TOP (CONTROL PANEL)

POWER WIPE PATTERN
ON
WH1 WH2
OFF
S F 0 S F 1
YLW CYN
INCOM
MWR I N T
MGT RED
LEVEL
GEN-LOCK PHASE
SETTING
H SC SC FINE
A
1 2 3
B
Q Power Indicator [POWER]
Lights (green) when power is supplied to DC Power Input Terminal L and Power Switch
W set to the ON position, and goes out when Power Switch W is set to the OFF position.
W Power Switch [POWER ON/OFF]
Power is switched on and Power Indicator Q lights when this switch is set to the ON
position, provided that power is supplied to DC Power Input Terminal L. Power is
switched off and Power Indicator Q goes out when the switch is set to the OFF position.
Caution
Even when the Power Switch is at the OFF position, some of the power supply circuits
are still operating. To turn off the power completely, set the external power adaptor to
OFF.
Live Switcher AW-SW350
TRANSITION TIME
AUTO TAKE KEY AUTO
WH3
A
S F 2
GRN
KEY
F R Z
GAIN CLIP
BLE
I N V
SOURCE KEY AUTO
IN5
COLOR
N
N / R
FMEM
R
FRZ
MIX
WIPE
5 BLACK
4 COLOR
FMEM
BAR
AUTO TAKE
B
8 (E)
E Wipe Pattern Selection Switches [WIPE PATTERN]
To select a wipe pattern after pressing Wipe Switch y. One of the nine patterns can be
selected. The selected switch lights.
R Setting Switch [SETTING]
This functions as the shift key for the wipe patterns. While it is held down, the Wipe Pattern
Selection Switches can select the functions described below. The functions are indicated
with blue characters.
SF0 SF1
MWR INT
SF0, SF1, SF2: These are used to set the three wipe softness levels.
The minimum softness level is set by SF0 (a hard key), and the maximum
softness level is set by SF2.
MWR: This makes it possible for the user to set the initial statuses of the panel
when the power is turned on.
First, set the statuses of the panel to be recorded. Once the setting has
been performed, keep pressing MWR while holding down the SETTING
switch until the nine switches go off. The recorded statuses will be
reproduced when the power is next turned on.
INT: This is used to restore the initial settings which were established at the
factory.
Keep pressing INT while holding down the SETTING switch until the nine
switches go off. The same statuses as the factory setting statuses will be
established when the power is next turned on.
FRZ: This is used to set the freezing of the Video Input 5 signal to ON or OFF.
When FRZ is pressed while holding down the SETTING switch, the Video
Input 5 signal is frozen. While the signal is frozen, the FRZ w LED lights.
This signal can be used as the source of the VIDEO IN 5 signal.
If the freeze function is used while the FS switch is in the OFF position,
only the Video Input 5 signal will be set to the FS ON status.
SF2
FRZ
INV
9 (E)