Installing The Device Driver - Panasonic AW-SW350E Operating Instructions Manual

INSTALLING THE DEVICE DRIVER

This section describes how to install the device driver used with the USB image transfer
programme for the AW-SW350. In the example of the procedure given below,
Windows XP is used as the operating system.
1
Insert the CD-ROM supplied with the AW-SW350 in the CD-ROM drive of the host
computer. (In this example, E: is the drive used.)
2
Set the AW-SW350's Power Switch to ON, check that the Power Indicator has lit, and
connect one end of the A-B type USB cable to the USB port on the rear panel of the
AW-SW350 and the other end to the USB port on the host computer. (Fig.1)
VIDEO
BBOUT GLIN PVW PGM OUT
2 1 5 4 3 2 1
/BBOUT OUT
TALLY & INCOM
5 4 3 2 1
Y / C IN
PGM
DC 12V IN EXT Y / C
USB
SET UP TAKE
OUT
1 2 3 4
5 4 3 2 1
GND
AW-SW350
Fig.1 Connections
3
When the host computer recognizes the AW-SW350, as shown in Fig.2, the Found
New Hardware Wizard automatically starts up.
Fig.2 Found New Hardware Wizard start screen
IN
Windows PC
75
AUTO
OUT
Rear
USB cable
22 (E)
4
When the screen for specifying the driver loading directory appears as shown in Fig.3,
specify the \DRIVER folder of the drive where the CD-ROM supplied with the
AW-SW350 was inserted, and load the driver. (In this example, E: is the drive used.)
Fig.3 Driver specification screen
5
When the device driver has been loaded, a screen similar to the one shown in Fig.4
appears. This completes the installation of the device driver.
Fig.4 Driver loading completion screen
23 (E)