Advertisement
General safety in operation
These instructions are for all personnel that operate the drive.
WARNING! Obey these instructions. If you ignore them, injury or death, or damage to the equipment can
occur.
•
Do not control the motor with the line side disconnect at the drive power supply; instead, use the control
panel start and stop keys or commands through the I/O terminals of the drive.
•
Give a stop command to the drive before you reset a fault. If you have an external source for the start
command and the start is on, the drive will start immediately after the fault reset, unless you configure the
drive for pulse start. See
•
Before you activate automatic fault reset functions of the drive control program, make sure that no
dangerous situations can occur. These functions reset the drive automatically and continue operation
after a fault.
Note: When the drive is not in the Hand mode, the Off key on the control panel will not stop the drive.
Cybersecurity disclaimer
This product is designed to be connected to and to communicate information and data via a network
interface. It is Customer's sole responsibility to provide and continuously ensure a secure connection
between the product and Customer network or any other network (as the case may be). Customer shall
establish and maintain any appropriate measures (such as but not limited to the installation of firewalls,
application of authentication measures, encryption of data, installation of anti-virus programs, etc.) to protect
the product, the network, its system and the interface against any kind of security breaches, unauthorized
access, interference, intrusion, leakage and/or theft of data or information. ABB and its affiliates are not liable
for damages and/or losses related to such security breaches, any unauthorized access, interference,
intrusion, leakage and/or theft of data or information.
ACS580-0P GE SUPPLEMENT [3AXD50000875047]
ACS580 control program firmware manual (3AXD50000016097
[English]).
9
Advertisement
