Using The Remote 2 Terminal - Panasonic PT-D5500E Operating Instructions Manual

Using the REMOTE 2 terminal

Using the REMOTE 2 terminal provided on the side of the main unit, it is possible to operate the projector from a
control panel etc. furnished in a distant location where infrared remote control signal cannot be received.
Example of a control panel layout
Projector set up in a meeting room
Pin assignments and control
Be sure to short-circuit Pins
D-Sub 9-pin (female)
external appearance
• The following buttons on the remote control and the operation area of the projector can no longer
Note
be operated when pins
VIDEO button, S-VIDEO button, DVI button and SHUTTER button.
Neither will it be possible to use the RS232C commands or Web browser controls corresponding to
these functions.
40
and when controlling.
and are shorted: POWER button, RGB1 button, RGB2 button,
Remote terminal
Remote terminal/External control
STANDBY
RGB1
RGB2
DVI
Control panel located in a different room
Open (H)
Names of terminals
1 GND
2 POWER OFF
Other
3 RGB1
4 RGB2 Other
5 VIDEO Other
6 S-VIDEO Other
7 DVI Other
8 SHUTTER OFF
9 RST / SET
Controlled by remote control
External control
ON
LAMP
VIDEO
S-VIDEO
Short (L)
GND
ON
RGB1
RGB2
VIDEO
S-VIDEO
DVI
ON
Controlled by external contact