E-mail setup page
With this projector, if a problem occurs or if the lamp usage time reaches a set value, an e-mail message can be
sent to one or more preset e-mail addresses (maximum two addresses). Click [Projector Control], then [E-mail
set up] to display the E-mail setup page.
E-mail Enable/Disable toggling
Minimum sending interval field
(applies only to temperature warnings)
ON/OFF toggling for permission
to send e-mail when error occurs
ON/OFF toggling for permission to
send e-mail based on lamp usage time
SMTP server field
Set temperature selection
Destination e-mail address field
Change lamp usage
time set value
Periodic warning interval setting
(e-mail is sent on the checked days of the week/times)
The settings for e-mail address 1 are the same.
Button to update settings
Sender field
Memo field
(alphanumeric characters)
ON/OFF toggling for permission to
send e-mail based on air intake
sensor temperature
49