StarTech.com 127B-USBC-MULTIPORT Quick Start Manual page 2

Installation
Side A Ports
Connect the Built-in USB-C Host Cable, located on the Multiport Adapter, to a
1.
USB-C Port on your Host Computer. Your Host Computer will automatically detect
the Multiport Adapter and install the required drivers.
Connect an HDMI Enabled Display Device, to the HDMI Output Port, located on
2.
the Multiport Adapter, using an HDMI cable.
Notes:
The Host Computer's USB-C port must support DP Alt Mode in order to output
•
video.
Video performance, such as resolution, and refresh rate depends upon the
•
connected Host Computer's video controller. Please verify the specifications of
the Host Computer.
Connect USB Peripheral Devices to the USB-A Data Ports, located on the
3.
Multiport Adapter.
Note: The USB-A Data Ports will output whatever bus power is available, up
to 4.5 W.
Side B Port
Connect a USB-C Power Adapter (up to 100 W) from an AC outlet to the
4.
100 W Power Delivery Port on the Multiport
Computer that's connected to the Built-in USB-C Host Cable.
Note: The Multiport Adapter reserves 15 W of power, with up to 85 W
available for charging your Host Computer.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected names and/or symbols of third-
party companies not related in any way to StarTech.com. Where they occur these references are for illustrative purposes only
and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. StarTech.com hereby acknowledges that all trademarks, registered
trademarks, service marks, and other protected names and/or symbols contained in this manual and related documents are the
property of their respective holders.
PHILLIPS® is a registered trademark of Phillips Screw Company in the United States or other countries.
Warranty Information
This product is backed by a 3-year warranty.
For further information on product warranty terms and conditions, please refer to www.startech.com/warranty.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their officers, directors, employees or agents)
for any damages (whether direct or indirect, special, punitive, incidental, consequential, or otherwise), loss of profits, loss of
business, or any pecuniary loss, arising out of or related to the use of the product exceed the actual price paid for the product.
Some states do not allow the exclusion or limitation of incidental or consequential damages. If such laws apply, the limitations
or exclusions contained in this statement may not apply to you.
StarTech.com StarTech.com LLP StarTech.com Ltd.
Ltd.
4490 South Hamilton Unit B, Pinnacle 15
Gowerton Rd,
45 Artisans Cres Road
London, Ontario Groveport, Ohio Brackmills
Northampton
N5V 5E9 43125
NN4 7BW
Canada U.S.A.
United Kingdom
USB-C
Adapter, to charge the Host
FR: startech.com/fr
StarTech.com Ltd.
DE: startech.com/de
Siriusdreef 17-27
ES: startech.com/es
2132 WT Hoofddorp
NL: startech.com/nl
The Netherlands
IT: startech.com/it
JP: startech.com/jp
Side C Port
Connect an RJ-45 terminated network cable (CAT5e or better) from your Network
7.
Device (e.g. Router, Switch, Modem, etc.) to the Gigabit Ethernet Port on the
Multiport Adapter, to access the network via a wired LAN connection.
Regulatory Compliance
FCC -- Part 15
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications not expressly approved by StarTech.com could void
the user's authority to operate the equipment.
Industry Canada Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du Canada.
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) This device may not cause interference, and (2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation
est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IC Radiation Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limit set forth for an uncontrolled environment. This equipment
should be installed and operated with minimum distance 20cm between the radiator and your body.