TABLE OF CONTENTS PAGE PAGE 1 Safety Precaution -------------------------------------------------3 1.1. General Guidelines ----------------------------------------3 1.2. Leakage Current Cold Check ---------------------------3 1.3. Leakage Current Hot Check (See Figure 1.)--------3 1.4. How to Discharge the Capacitor on Flash Top PCB------------------------------------------------------------4 2 Warning --------------------------------------------------------------5 2.1.
1 Safety Precaution 1.1. General Guidelines 1.3. Leakage Current Hot Check 1. IMPORTANT SAFETY NOTICE (See Figure 1.) There are special components used in this equipment 1. Plug the AC cord directly into the AC outlet. Do not use which are important for safety. These parts are marked by an isolation transformer for this check.
1.4. How to Discharge the Capacitor on Flash Top PCB CAUTION: 1. Be sure to discharge the capacitor on FLASH TOP PCB. 2. Be careful of the high voltage circuit on FLASH TOP PCB when servicing. [Discharging Procedure] 1. Refer to the disassemble procedure and Remove the necessary parts/unit. 2.
2 Warning 2.1. Prevention of Electrostatic Discharge (ESD) to Electrostatically Sensitive (ES) Devices Some semiconductor (solid state) devices can be damaged easily by static electricity. Such components commonly are called Elec- trostatically Sensitive (ES) Devices. The following techniques should be used to help reduce the incidence of component damage caused by electrostatic discharge (ESD).
A replacement fuse cover can be purchased from your local 2.3.2.3. How to Replace the Fuse Panasonic Dealer. 1. Remove the Fuse Cover with a screwdriver. If the fitted moulded plug is unsuitable for the socket outlet in your home then the fuse should be removed and the plug cut off and disposed of safety.
2.4. How to Replace the Lithium Battery 2.4.1. Replacement Procedure 1. Remove the MAIN PCB. (Refer to Disassembly Procedures.) 2. Remove the Lithium battery (Ref. No. “B9101” at foil side of MAIN PCB) and then replace it into new one. NOTE: This Lithium battery is a critical component.
3 Service Navigation 3.1. Introduction This service manual contains technical information, which allow service personnel’s to understand and service this model. Please place orders using the parts list and not the drawing reference numbers. If the circuit is changed or modified, the information will be followed by service manual to be controlled with original service manual. 3.2.
3.3. How to Define the Model Suffix (NTSC or PAL model) There are five kinds of DMC-FS5, regardless of the colours. • a) DMC-FS5P/PC • b) DMC-FS5E/EB/EF/EG/GN • c) DMC-FS5EE • d) DMC-FS5GT/GK • e) DMC-FS5PL/GC/PR/GJ What is the difference is that the “INITIAL SETTINGS” data which is stored in Flash ROM mounted on Main PCB. 3.3.1.
Page 10
3.3.2. INITIAL SETTINGS: When you replace the Main PCB, be sure to perform the initial settings after achieving the adjustment by ordering the following pro- cedure in accordance with model suffix of the unit. 1. IMPORTANT NOTICE: Before proceeding Initial settings, be sure to read the following CAUTIONS. 2.
Page 11
• Step 5. Set the INITIAL SETTING: (Refer to “CAUTION 1”) [Caution for befor settings] Once "NONE(JAPAN)" (Area for Japan) or "P" (Area for Noth America) is selected with "INITIAL SETTINGS", other areas will not displayed even if "INITIAL SETTINGS" menu is displayed again, thus, the area can not be changed. Select the area carefully.
5 Service Fixture & Tools 5.1. When Replacing the Main PCB After replacing the MAIN PCB, be sure to achieve adjustment. The adjustment instruction is available at “software download” on the “Support Information from NWBG/VDBG-PAVC” web-site in “TSN system”, together with Maintenance software. 5.2.
6 Maintenace 6.1. Cleaning Lens and LCD Panel Do not touch the surface of lens and LCD Panel with your hand. When cleaning the lens, use air-Blower to blow off the dust. When cleaning the LCD Panel, dampen the lens cleaning paper with lens cleaner, and the gently wipe the their surface. Note: The Lens Cleaning KIT ;...
Page 15
DSC0802006CE S1. About Indication of The Schematic Diagram Service Manual S1.1. Important Safety Notice COMPONENTS IDENTIFIED WITH THE MARK HAVE THE SPECIAL CHARACTERISTICS Diagrams and Replacement FOR SAFETY. WHEN REPLACING ANY OF THESE COMPONENTS USE ONLY THE SAME TYPE. 1.Although reference number of the parts is indicated on the P.C.B. drawing and/or Parts List schematic diagrams, it is NOT mounted on the P.C.B.
S2. Voltage Chart Note) Indicated voltage values are the standard values for the unit measured by the DC electronic circuit tester (high-impedance) with the chassis taken as standard. Therefore, there may exist some errors in the voltage values, depending on the internal impedance of the DC circuit tester. S2.1.
S4.2. Jack(J) Schematic Diagram CAUTION: FOR CONTINUED PROTECTION AGAINST FIRE HAZARD, REPLACE ONLY WITH THE SAME TYPE 1.5A 32V FUSE. ATTENTION: POUR UNE PROTECTION CONTINUE LES RISQUES 1.5A 32V D' INCENDIE N' UTILISERQUE DES FUSIBLE DE MÉME TYPE 1.5A 32V. 1.5A 32V DMC-FS5 Jack Section...
S6. Replacement Parts List Note: 1.* Be sure to make your orders of replacement parts according to this list. 2. IMPORTANT SAFETY NOTICE Components identified with the mark have the special characteristics for safety. When replacing any of these components, use only the same type. 3.
Page 46
DMC-FS5P/PC/PL/PR/EB/EE/EF/EG/E/GC/GK/GN/GT/GJ Ref.No. Part No. Part Name & Description Remarks Ref.No. Part No. Part Name & Description Remarks C5004 ECJ0EB1A473K C.CAPACITOR CH 10V 0.047U ------ P.C.B. LIST ------ C5005 F1G0J1050007 C.CAPACITOR CH 6.3V 1U VEP56057A MAIN P.C.B. 1 (RTL) E.S.D. C5006 ECJ0EB1A473K C.CAPACITOR CH 10V 0.047U C5007 F1G0J1050007...
Page 47
DMC-FS5P/PC/PL/PR/EB/EE/EF/EG/E/GC/GK/GN/GT/GJ Ref.No. Part No. Part Name & Description Remarks Ref.No. Part No. Part Name & Description Remarks QR1101 B1GBCFJN0041 TRANSISTOR-RESISTOR 1 E.S.D. CX6001 F1L1E103A065 C.CAPACITOR CH 25V 0.01U QR1102 B1GBCFNJ0014 TRANSISTOR-RESISTOR 1 E.S.D. CX6002 F1L1E103A065 C.CAPACITOR CH 25V 0.01U QR6001 B1GKCFNL0001 TRANSISTOR-RESISTOR 1 E.S.D.
Page 48
DMC-FS5P/PC/PL/PR/EB/EE/EF/EG/E/GC/GK/GN/GT/GJ Ref.No. Part No. Part Name & Description Remarks Ref.No. Part No. Part Name & Description Remarks R7017 ERJ2BQFR56 M.RESISTOR CH 1/16W 0.56 R7131 ERJ2GEJ151 M.RESISTOR CH 1/16W 150 R7132 ERJ2GEJ151 M.RESISTOR CH 1/16W 150 R7133 ERJ2GEJ221 M.RESISTOR CH 1/16W 220 R7134 ERJ2GEJ183 M.RESISTOR CH 1/16W 18K...
Need help?
Do you have a question about the Lumix DMC-FS5P and is the answer not in the manual?
Questions and answers