Download
Share
Print this page
NCR 2-in-1 Sign-In Kit Instructions
  1. Manuals
  2. Brands
  3. NCR Manuals
  4. Control Unit
  5. 2-in-1 Sign-In
  6. Kit instructions

NCR 2-in-1 Sign-In Kit Instructions

Hide thumbs
1
2
3
4
5
6
7
8
9

Advertisement

Quick Links

Download this manual
Kit Instructions
2-in-1 Sign-In
7772-K161
Issue B

Advertisement

loading

Related Manuals for NCR 2-in-1 Sign-In

Summary of Contents for NCR 2-in-1 Sign-In

  • Page 1 Kit Instructions 2-in-1 Sign-In 7772-K161 Issue B...

  • Page 2: Revision Record

    NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.

  • Page 3: Kit Contents

    2-in-1 Sign-In This kit provides a 2-in-1 Sign-In Module for NCR CX7 All-in-One POS (7772) or NCR CX5 All-in-One POS (7773). Kit Contents...

  • Page 4: Installation Procedure

    2-in-1 Sign-In Installation Procedure Warning: Disconnect the AC power cord from the AC outlet and wait 30 seconds before servicing the terminal. 1. Lay the Display face down on a flat surface. Note: Always use a soft material (cloth, foam) to protect the display screen when placing the terminal face down.
  • Page 5 2-in-1 Sign-In 3. Disconnect the Cables. a. Loosen the thumbscrew of the 180-degree USB-C Cable then disconnect the Cable. b. Remove the Ethernet Cable from the Cable Management Hook then disconnect the Cable. 4. Loosen the two (2) captive screws that secure the Back Cover to the Display.
  • Page 6 2-in-1 Sign-In 5. Rotate the Back Cover away from the Display and unhook the Back Cover Tabs.
  • Page 7 6. Insert a flat screw driver in the slot of Port C to unsnap the Plate from the display housing. 7. Place the 2-in-1 Sign-In Front Housing Assembly under the front of the display, then route the 2-in-1 Sign-In Cable through the Port opening and pull the Cable...
  • Page 8 8. Route and secure the Cable under the Cable Management Hooks as shown, then connect the Cable to the Motherboard. Place excess cable in the area shown. 9. Hook the 2-in-1 Sign-In Rear Housing into the display housing and lower into place.
  • Page 9 2-in-1 Sign-In 10. Secure the Rear Housing with three (3) screws. 11. Reinstall the Display Back Cover. 12. Reconnect the 180-degree USB-C Cable and Ethernet Cable. 13. Reinstall the Cable Cover.