Verification Stamp - Panasonic DP-C323, DP-C263, DP-C213 Operating Instructions Manual

Verification Stamp

This function confirms successful transmission, or storage
into the memory by stamping at the bottom of each
successfully transmitted original(s) with a small "x" mark.
The standard setting of the verification is "Off". The stamp setting can be changed with "04 Stamp (HOME)" in
Function Parameters (Fax/Email Settings> Fax Parameters). For instructions on how to change the standard setting,
refer to Fax/Email Settings in the Operating Instructions (For Function Parameters) on the provided CD-ROM.
The machine can be configured not to stamp the documents stored in the memory by changing the setting
"28 Stamp at Memory XMT" in Function Parameters (Fax/Email Settings> Fax Parameters). For instructions
on how to configure the verification stamp, refer to Fax/Email Settings in the Operating Instructions (For
Function Parameters) on the provided CD-ROM.
Verification Stamp function is only available when scanning documents with the ADF.
Because the verification stamp cannot be deleted, be careful not to use the verification stamp when
transmitting important document(s).
1
Place Original(s).
Refer to Placing Originals (Facsimile/Internet
Fax) in the Operating Instructions (For Basic
Operations) of provided booklet.
2
Press the Fax key.
3
Select "Basic Menu".
4
Select "Verification Stamp".
34
Verification Stamp
5
Set "Quality Adj." as required.
Refer to Setting Original Quality (see page
26).
6
Select "Address Book", and then
select a destination.
画像ファイル名、
image_026_2.tifに変更してリンクしていま
す。
Refer to Entering a Destination (see page
16).
7
Press the Start key.
The original(s) are stored into memory with a
file number. Then starts dialing the telephone
number.
The setting of the "Verification Stamp" is
returned to the "Off" position after the
transmission is completed.
Ex: Scanning
Direction