Panasonic DP-C323, DP-C263, DP-C213 Operating Instructions Manual page 210

Info. code
495 Telephone line disconnected.
501/502/503/ Communication error occurred
504 using the internal V.34 Modem.
540/541/542/ Communication error occurred
543/544 while transmitting.
550 Telephone line disconnected.
552/553/554/ Communication error occurred
555 while receiving.
580 Sub-address transmission to a
unit that has no Subaddress
function.
581 Sub-address Password
transmission to a unit that has
no Password Sub-address
function.
623 No document is loaded in the
ADF.
630 Redial was not successful due to
a busy line.
631/700 During dialing, STOP was
pressed.
634 Redial was not successful due to
no response from the called
station or wrong number dialed.
If a dial tone is not detected, the
machine does not transmit.
Note: If busy tone was not
638 Power failure occurred during
the communication.
711 Incorrect LDAP settings.
712 Incorrect email address.
714 Cannot log on to the LAN.
715 TCP/IP connection timed out.
210
Problem
detected, the machine will
only redial once.
Action
Check with the other party.
Check with the other party.
Reload the document and send again.
Check with the other party.
Check with the other party.
Check with the other party.
Check the remote station.
Check the remote station.
Resend the documents.
Reload the document and send again.
Reload the document and send again.
Check the telephone number, and send again.
Change the setting of "68 Dial Tone Check" is
set to "Off" in Function Parameters (Fax/Email
Settings> Fax Parameters).
Check the power cord and plug.
Check the LDAP Server Name, LDAP Log in
Name, LDAP password, LDAP Search Base.
Check the registered email address.
Check the IP Address of the SMTP Server with
the Network Administrator.
Check the 10Base-T/100Base-TX cable
connection. An unexpected LAN problem
occurred. Contact the Network Administrator.
Check the Internet Fax parameter settings.
Verify the IP Address, Default Gateway IP
Address, SMTP Server IP Address.
Refer to
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Function
Parameters)
Operating
Instructions (For
Setting Up)
Operating
Instructions (For
Setting Up)
Operating
Instructions (For
Setting Up)