Setting Up The Pneumatic Burner Cleaner; Setting Parameters - Atmos CP85KS Operation And Maintenance Manual

6. Setting up the pneumatic burner cleaner

With A85 burners the profile is set to A85 pneu as the factory setting, which is why you don't need to
perform any setting up.
Exact setting make according to the pellet type, see the table on page 16.
WARNING - check and secure everything before operating the pneumatic burner cleaner
so that everything is properly connected and secured according to the operation manual.

Setting parameters

• parameter Т5
pellets in the combustion chamber... (25 min)
• parameter S6
The first reserve R is used most commonly for controlling the boiler exhaust fan.
Set S6 = 3
• parameter S14
The second reserve R2 is used for controlling the pump in the boiler circuit.
Set S14 = 12
• parameter S67
module AC07X-C
The reserve R5 is used for controlling the air pump (compressor) for pellet burner pneumatic ash
cleaning system.
Set S67 = 15
• parameter S68
module AC07X-C
The reserve R6 is used for controlling the electric valve for pellet burner pneumatic ash cleaning
system.
Set S68 = 16
INFO - for standard setting when parameter S1 is set to a value of 2, you can connect an
appliance of maximum current 2.46 A (approx. 566 VA) to R, R2, R5 and R6 2 reserve
terminals together.
When setting where parameter S1 is set to a value of 4, which means that at the start both
ignition coils are run, you can connect an appliance of maximum current 0.29 A (approx.
67 VA) to R, R2, R5 and R6 reserve terminals together.
14-EN
Operation and Maintenance Manual - EN
– Rundown time of the fan after the STOP command - for optimal burning out of
– determines function of first reserve R - added output
– determins function of second reserve R2 - added output
– determins function of reserve R5 - added output with inbuilded additional
– determins function of reserve R6 - added output with inbuilded additional
www.atmos.cz