Video Equipment Connections - Onkyo TX-DS575x Instruction Manual

Video equipment connections

On each pair of input jacks, a red connector (marked R) corresponds to the right
channel, and a white connector (marked L) to the left channel.
A yellow connector (marked V) is used for video connection.
Please refer to the instruction manual of each component when making any con-
nections.
AUDIO OUTPUT
VIDEO OUTPUT
S-VIDEO OUTPUT
WARNING
RISK OF ELECTRIC SHOCK
DO NOT OPEN
ANTENNA
DVD
AM
VIDEO 3
VIDEO 2
FM
75
VIDEO 1
GND
(PLAY)
L TAPE
OUT
(REC)
R
PHONO C D
AUDIO OUT
AUDIO IN
VIDEO OUT
Video Cassette Recorder
Notes:
When using a playback-only VCR, connect it to VIDEO 2 or VIDEO 3. If you connect it to VIDEO 1, you need to make only the out-
put connections.
This receiver can be used with only a monitor TV equipped with a video input jack.
Interference may be caused between the TV and this receiver. If this interference occurs, place the receiver and the TV as far apart
as possible. We do not recommend the use of a common TV/FM antenna (see antenna section).
A DVD or other component equipped with a digital output can be connected to this receiver. The digital connection must be used in
conjunction with an analog connection, because if the analog cable is disconnected, the audio output from TAPE OUT (REC) and
VIDEO 1 OUT will not work.
A signal input from the S-video connector will be routed to the S-video out, and the signal input from the video connector will be
routed to the video out.
Refer to the instruction manual for the devices you wish to connect for information on whether you need to connect only the S-video
connector, or both S-video connector and video connector.
Remove the protective cap attached to the DIGITAL INPUT (OPTICAL) jack before making the connection. When this jack is not
used, replace the protective cap.
DVD Player
DIGITAL COAXIAL OUTPUT
DIGITAL OPTICAL OUTPUT
AVIS
RISQUE DE CHOC ELECTRIQUE
NE PAS OUVRIR
L
R L V S
I N
R
I N
I N
I N
FRONT
OUT
R
SURROUND
MONITOR
V S
I N
OUT
R
SUBWOOFER
PRE OUT
CENTER
R L MULT I CH I NPUT
S-VIDEO OUT
S-VIDEO IN
VIDEO IN
Digital audio connections
This receiver has a powerful digital signal
processor for use with DVD players, DAT
decks, and CD players. The digital inputs,
COAXIAL 1, 2 and OPTICAL1, 2 can be
assigned to individual input selector buttons,
so when an input selector button is pressed, the
assigned digital input is used instead of the
corresponding analog input. (See page 18.)
DIGITAL INPUT
COAXIAL 2
L
COAXIAL 1
FRONT
SPEAKERS
A
OPTICAL 2
R
OPTICAL 1
CENTER
SPEAKER
REMOTE CONTROL
L
L
AV RECEIVER
MODEL NO. TX-DS575X
SUB
WOOFER
S-VIDEO IN
VIDEO IN
Monitor TV
Audio connection cable
L (Left)
R (Right)
Video connection cable
V (Video)
FRONT
SURROUND
SPEAKERS B SPEAKERS
L L
R R
AC OUTLETS
AC 230V 50Hz SWITCHED
TOTAL 100W MAX.
: signal flow
S-VIDEO OUT
VIDEO OUT
AUDIO OUT
VDP Player
L
R
V
7