Balboa BP600 Manual page 2

Introduction
Intellectual Property Advisement
All Intellectual property, as defined below, owned by or
which is otherwise the property of Balboa Water Group or its
respective suppliers relating to the Balboa Water Group BP
Spa Control Systems, including but not limited to, accessories,
parts, or software relating to the "System" , is proprietary
to Balboa Water Group and protected under federal laws,
state laws, and international treaty provisions. Intellectual
Property includes, but is not limited to, inventions (patentable
or unpatentable), patents, trade secrets, copyrights, software,
computer programs, and related documentation, and other
works of authorship. You may not infringe or otherwise violate
the rights secured by the Intellectual Property. Moreover,
you agree that you will not (and will not attempt to) modify,
prepare derivative works of, reverse engineer, decompile,
disassemble, or otherwise attempt to create source code
from the software. No title to or ownership in the Intellectual
Property is transferred to you. All applicable rights of the
Intellectual Property shall remain with Balboa Water Group
and its suppliers.
End User Warning
This Installation Manual is provided solely to aid qualified spa
service technicians in installing spas with control systems
manufactured by Balboa Water Group. Balboa controls have
absolutely no end user serviceable parts. Balboa Water Group
does not authorize attempts by the spa owner/user to repair or
service any Balboa products. Non-qualified users should never
open or remove covers, as this will expose dangerous voltage
points and other dangerous risks. Please contact your dealer or
authorized repair center for service.
RCD
It is strongly advised to install an RCD (Residual Current
Device) in the supply power to a spa. Also, an RCD should be
tested periodically. This device will trip the breaker if there
is an unsafe electrical condition caused by a malfunctioning
component or even the slightest short to ground.
Note: Follow all local electrical codes upon installation,
diagnosis, or testing of the RCD.
Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,
2
Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.
Warnings: Danger! Risk of Electric Shock!
All electrical work must be performed by a qualified electri-
cian and must conform to all national, state, and local codes.
Before making any electrical connections, make certain that
the Main Power breaker from the house breaker box has
been turned off.
Do not attempt service of this control system unless you
are qualified. Contact your dealer or service organization for
assistance.
Do not permit any electric appliance, such as a light, tele-
phone, radio, or television within 5' (1.5m) of a pool or spa.
Follow all owner's manual power connection instructions.
Installation must be performed by a licensed electrician and
all grounding connections must be properly installed.
No user serviceable parts.
Water temperature in excess of 38˚C may be injurious to
your health.
Disconnect the electrical power before servicing.
Keep access door closed.
CAUTION
Test the ground fault circuit interrupter before each use of
the spa.
Read the instruction manual.
Adequate drainage must be provided if the equipment is to be
installed in a pit.
To ensure continued protection against shock hazard, use
only identical replacement parts when servicing.
Install a VG Compliant suction guard that is suitably rated to
match the maximum flow rate marked.
WARNING:
Water temperature in excess of 38˚C may be injurious to
your health.
Disconnect the electrical power before servicing.
Keep access door closed.
© 2013 Balboa Water Group. All Rights Reserved.
2013-06-22