Balboa BP600 Manual page 12

Hide thumbs Also See for BP600:

Tech sheet (23 pages)

Table Of Contents

Table of Contents

TP400, TP600 Messages (cont.)

FALT LOG (FAULT LOG)

The Fault Log is a record of the last 24 faults that can be re-

viewed by a service tech.

SCROLLING TP400/TP600 MESSAGES

The following messages will scroll across the TP400/TP600 pan-

els. NOTE: LCD readouts may look slightly different than shown

on screen.

RUN PMPS PURG AIR ----

PRIMING MODE – M019

Each time the spa is powered up, it will enter Priming Mode. The

purpose of Priming Mode is to allow the user to run each pump

and manually verify that the pumps are primed (air is purged)

and water is flowing. This typically requires observing the output

of each pump separately, and is generally not possible in normal

operation. Priming Mode lasts 4 minutes, but you can exit it

earlier by pressing any Temp button. The heater is not allowed to

run during Priming Mode.

NOTE: If your spa has a Circ Pump, it will turn on with Jets 1 in

Priming Mode. The Circ Pump will run by itself when Priming

Mode is exited.

-- -- -- F -- -- -- C

Water Temperature is Unknown

After the pump has been running for 1 minute, the temperature

will be displayed.

42 F TOO COLD

Too Cold - Freeze Protection

A potential freeze condition has been detected, or the Aux Freeze

Switch has closed, and all pumps and blower are activated. All

pumps and blower are ON for at least 4 minutes after the poten-

tial freeze condition has ended, or when the aux freeze switch

opens. In some cases, pumps may turn on and off and the heater

may operate during Freeze Protection. This is an operational

message, not an error indication.

WATR TOO HOT -- -- -- --

Water is too Hot (OHS) – M029

One of the water temp sensors has detected spa water temp

110°F (43.3°C) and spa functions are disabled. System will auto

reset when the spa water temp is below 108°F (42.2°C). Check

Manufactured under one or more of these patents. U.S. Patents: 5332944, 5361215, 5550753, 5559720, 5,883,459, 6253227, 6282370, 6590188, 6976052, 6965815, 7030343, 7,417, 834 b2,

Canadian Patent: 2342614, Australian patent: 2373248 other patents both foreign and domestic applied for and pending. All material copyright of Balboa Water Group.

42217 C

for extended pump operation or high ambient temp.

SFTY TRIP -- -- -- --

Safety Trip - Pump Suction Blockage* – M033

The Safety Trip error message indicates that the vacuum switch

has closed. This occurs when there has been a suction problem

or a possible entrapment situation avoided. (Note: not all spas

have this feature.)

HTR FLOW LOSS -- -- -- --

Heater Flow is Reduced (HFL) – M016

There may not be enough water flow through the heater to carry

the heat away from the heating element. Heater start up will