Onkyo TX-DS484 Instruction Manual page 18

Selecting a sound source
1
2
LEFT
SUBWOOFER
1
2
3
18
SUR MULTI-CH
POWER
SLEEP DIMMER MODE INPUT
INPUT SELECTOR
DVD TAPE TUNER PHONO C D
VIDEO-1 VIDEO-2 PRESET
TUNER
C D DVD
MULTI-CH
DISC
INPUT
TAPE CH SEL
TEST
TONE
VOLUME
LEVEL
MUTING
REMOTE CONTROLLER RC-427S
CENTER RIGHT
L-SUR R-SUR
SUR
POWER MULTI-CH CH SEL
SLEEP DIMMER MODE INPUT
TEST
INPUT SELECTOR
DVD TAPE TUNER PHONO C D
TONE
VIDEO-1 VIDEO-2
PRESET
TUNER
C D DVD
DISC
TAPE
CH SEL
TEST
TONE
LEVEL
LEVEL VOLUME
MUTING
REMOTE CONTROLLER RC-427S
MASTER VOLUME
PARAMETER SELECTOR
PARAMETER CONTROLLER
PARAMETER SELECTOR
PARAMETER CONTROLLER
When Multi channel input is selected as a source
Follow the steps below to adjust the level of each speaker if you
have selected MULTI CH INPUT.
1. Press MULTI CH INPUT button on the remote controller.
You cannot select any Surround mode.
2. Press the CH SEL button to select the desired speakers.
3. Use the LEVEL π/† button to change the volume level of
the speakers.
You can adjust the volume level of each speaker individually. Adjust
the level while listening to the sound in the listening position.
You can adjust the level of the front, center, and surround speak-
ers in the range between –12dB and +12dB.
You can adjust the subwoofer level in the range between –30dB
and +12dB.
Note
If the speaker level is set to +1dB or higher, the maximum level
indicated on the display will change if you raise the volume
level.
Using the Power On Volume function
This function automatically selects the volume level you set last
time.
Follow the steps below:
1. Use the VOLUME control to set the desired level.
2. Press the PARAMETER SELECTOR √ or ® button
repeatedly to display the "PWR ON VOL" parameter.
The current setting (ON or OFF) appears.
3. Press the PARAMETER CONTROLLER √ or ® button to
select "ON."
Even if the parameter has already been set to ON, turn it OFF,
then turn it ON again to enable the Power On Volume function.
The original display appears and the setting is completed. When
you turn on the power to the unit next time, it will use the vol-
ume level you set in step 1.
Note:
If the PWR ON VOL parameter is set to OFF, the Power On Vol-
ume function is disabled. In this case, when you turn on the power
to the unit next time, it will use the volume level that was set when
you turned off the power.