6.2.2.11. Installation of the Shading Frame
1. Install the Shading Frame.
2. Tighten 2 screws (B) in numerical order
by using the torque driver with specified torque.
①
Screw (B)
Screw Order
Torque
6.2.2.12. Installation of the Filter Ring
1. Install the Filter Ring.
2. Tighten 3 screws (A) in numerical order
by using the torque driver with specified torque.
③
Screw (A)
Screw Order
Torque
②
Screw (B) x 2
① → ②
10.0 ± 1.0 N ・cm
②
①
Screw (A) x 3
① → ② → ③
7.0 ± 1.0 N ・cm
6.2.2.13. Installation of the Decoring Unit
1. Insert the 3 Pins of the Decoring Unit to the hole of
the Filter Ring.
・Use new one, do not use the one which is removed.
・Double-stick tape sticks to the Decoring Unit of the
repair part. Remove the old double-stick tape from
the Filter Ring.
2. After installing the Decoring Unit, use a soft cloth to
press it into place.
Decoring Unit
(Reverse side)
16
Pin
Decoring Unit
Filter Ring
Hole