Table of Contents
Advertisement
6.1.2.
Disassembly Procedure
Important：
It must be performed inside of satisfied clean level.
(Satisfied clean level: Less than class 10,000
(Federal Standard 209D))
6.1.2.1. Removal of the Decoring Unit
1. The Decoring Unit is sticked on the Filter Ring.
2. Put the sheet so that the lens glass is fullty covered.
3. Insert the small flat blade screwdriver to Gap (between
the Decoring Unit and lens glass), and peel off
the Decoring Unit gently.
6.1.2.2. Removal of the Filter Ring
1. Remove 3 screws (A) and the Filter Ring.
Screw (A)
Screw (A) ｘ 3
6.1.2.3. Removal of the Shading Frame
1. Remove 2 screws (B) and the Shading Frame.
Screw (B)
6.1.2.4. Removal of the L Mount Unit
1. Remove screw (C) and 3 screws (D).
2. Remove the L Mount Unit.
Screw (C)
Screw (D)
Screw (C) Screw (D) ｘ 3
7
Screw (B) ｘ 2
Advertisement
Table of Contents
