Cleaning And Servicing - Bosch MMB21 GB Series Instruction Manual

Working with the smoothie insert
With this insert it is particularly easy to make
smoothies made of fresh fruits, milk, soya
milk, yoghurt and juices.
Fig.

Prepare blender as described above.

After attaching and screwing on the

blender jug, the smoothie insert
is inserted into the blender jug.
Put lid on and press down all the way.

Insert the mains plug.

Put ingredients through the feed tube into

the blender jug; chop up fruit beforehand
if required.
Warning!
Do not put large, hard ingredients in the
blender jug, e.g. stones from avocados
or plums.
Insert measuring cup into feed tube.

Switch on the appliance.

After using the appliance
Set the rotary switch to 0/off.

Remove mains plug.

Remove the blender jug by rotating

it in an anti-clockwise direction.
Remove lid.

Take measuring cup out of the lid

and plug into the smoothie insert.
This prevents integral components from
falling out of the insert into the drink.
Empty blender jug.

Clean all parts, see "Cleaning and

servicing".

Cleaning and servicing

The appliance requires no maintenance!
Thorough cleaning guarantees a long service
life. An overview of cleaning the individual
parts can be found in Fig. .
Risk of electric shock!
Never immerse the motor block in water
and never hold under running water and
do not clean in the dishwasher.
Warning!
Do not use abrasive cleaning agents.
Surfaces may be damaged.
Robert Bosch Hausgeräte GmbH
Tips:
– Preferably clean the parts immediately
after use. This will prevent residue
from drying on and attacking the plastic
(e.g. by essential oils in herbs).
– If processing e.g. carrots and red
cabbage, the plastic parts will become
discoloured by a red film which can be
removed with a few drops of cooking oil.
Cleaning the motor block
Remove mains plug.

Wipe motor block with a damp cloth.

If required, use a little detergent.
Then wipe dry.

Cleaning the blender
The blender jug, lid and measuring cup are
dishwasher-safe.
Tip: Pour a little water and washing-up liquid
into the attached blender. Switch to setting
Pulse for several seconds. Pour out the water
and rinse the blender with clean water.
Cleaning blade holder
(only MMB42...)
Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Do not clean blade holder in the dishwasher,
but under running water using a brush.
Do not leave in water!
Remove seal for cleaning.
Troubleshooting
Risk of injury!
Before rectifying a fault, pull out the mains
plug.
Fault:
Blender does not start or appliance switches
off during operation.
Possible cause:
The appliance was overloaded (e.g. tool
jammed by food) and the electronic fuse
has tripped.
en
15