Signs - RAYLASE MINISCAN II Manual

Basic safety instructions
1.3

Signs

The following signs must be attached to the subsystem. These signs may not be removed.
Signs that have become illegible must be replaced.
MN071 / v1.0.0
The rating plate and the identification code printed on it allow
the type of the deflection unit to be determined ( page 13,
Rating plate code). The serial number and the part number are
also used to identify the deflection unit.
The CE symbol confirms the deflection unit's compliance with
European directives. It indicates that the deflection unit is ap-
proved for free trade within the EU.
The seal label warns against unauthorized opening of the de-
flection unit. If the seal is broken, all warranty claims against
RAYLASE are void.
A laser warning sign must be attached at the point where
laser radiation is emitted. This provides information about the
type of radiation, specific hazards and the degree of protection.
The laser warning sign is attached by the OEM customer in
accordance with the laser device's classification ( page 6,
Classification of laser devices).
In the high-speed versions of the subsystem the mirrors are
made from beryllium.
To indicate this, these subsystems are labeled with the adja-
cent sign.
Also note  page 8, Special hazards caused by mirrors made
of beryllium.
Lenses for CO2 laser deflection units with linear translator
modules are made of zinc selenide.
To indicate this, these subsystems are labeled with the adja-
cent sign.
Also note  page 8, Special hazards caused by lenses made
of zinc selenide.
2-Axis Subsystems for Laser Beam Deflection
Chapter 1
5