Advertisement
V
ECTOR
2.2 LCD Display
Overview
This section explains the meaning of the symbols on the LCD Display of the different operation terminals.
2.2.1 OPT1 / TRI2 series Display
1
2
3
4
5
6
1
Control loop indication
-
When changing setpoints, the top bar indicates the control loop (1-4) that is being changed.
2
Indication side bar
-
The side bar represents the analog indication of a value while 1 bar represents a small value and all
bars active represent the maximum value.
-
No side bar is displayed if in configuration disabled.
-
When creating schedules, the sidebar serves as a navigation aid for the corresponding steps.
3
Fan is active
4
Fan auto mode
-
Fan speed is automatically regulated by the controller.
5
Operating Mode
-
See chapter 2.3
6
Touch buttons
-
See chapter 2.1.1
7
Large digits
8
Small digits
-
The large and small digits are used to show current input values, acting setpoints, alarms and errors,
submenu text or setup and configuration values, depending on the operating state of the controller.
9
Controlling Mode
-
See chapter 2.4
Alarm
-
See chapter 2.6
2.3 Operating Modes
Display
Mode
Occupied
(Comfort)
Unoccupied
(ECO)
Protection
OFF
(Holiday)
Doc: 70-07-0951A, 20220504
Subjects to alteration
Description
The X2 device maintains the occupied (comfort) temperature set points defined within each
control loop.
In occupied mode, the fan can be set to auto or manual fan speed.
The X2 device maintains the unoccupied (ECO, economy) temperature set points defined within
each control loop.
The X2 device runs in standby. The system is protected against overheating and frost if enabled.
Inputs are monitored for alarms.
© Vector Controls LLC, USA
www.vectorcontrols.com
X2-O
M
PERATIONS
ANUAL
6
7
8
9
T
D
OUCH
ISPLAY
Page 3-18
Advertisement
