Advertisement
V
ECTOR
5.4 Heat – Cool – Fan only – Auto selection
Overview
This section describes how to set the controlling mode of the X2 device.
Depending on the configured application, this submenu can have up to 5 different setting options or is deactivated
entirely.
Procedure
1.
Press the (
)button longer than 2 seconds.
➔ H–C and Sel or Auto is displayed.
2.
Press the (
) button and select one of the following functions:
Cooling:
=
Cooling only. The controller stays in cooling mode only
and will not switch to heating.
Fan only cooling:
The controller is in fan-only mode. The fan is controlled
=
according to the controller configuration or setpoint. The
cooling output is deactivated.
Heating:
=
Heating only. The controller stays in heating mode only
and will not switch to cooling.
Fan only heating:
The controller is in fan only heating mode. The fan is
=
controlled according to the controller configuration or
setpoint. The heating output is deactivated.
Auto operation:
Auto =
Heating and cooling changes automatically as required.
3.
Press the (
) button to finish the setup.
Doc: 70-07-0951A, 20220504
Subjects to alteration
X2-O
PERATIONS
© Vector Controls LLC, USA
www.vectorcontrols.com
M
T
D
ANUAL
OUCH
ISPLAY
Page 15-18
Advertisement
