Advertisement
V
ECTOR
8.
Press the (
) button to select Monday (Day 1).
9.
Press the ( ) button to execute the program on Monday (Day 1).
➔ 3 top bar symbols are displayed*.
10. Press the ( ) button to not execute the program on Monday (Day 1).
➔ The 3 top bar symbols disappear*.
11. Press the (
) button to go to the next day.
➔ DAY1 (Day 1) and Pr01 (Program 1) is displayed in this example.
➔ 3 bars indicate setting step 3 is executed.
* 3 top bar symbols are displayed for a set execution.
12. Repeat this process to set DAY2 to DAY7 (Tuesday to Sunday).
13. Set the action to be performed by pressing the ( ) ( ) and
(
) button depending on function selected in instruction No. 6:
a.
OP (operating mode):
ON = Occupied, normal operation
ECO = Unoccupied, reduced operation
OFF = protective operation
b.
LP (control loop set point) LP01-LP0x*:
°C/°F
c.
AO (analogue output position) Ao01-Ao0x**:
0-100%
d.
FAN (fan control, fan speed) FAN1-FAN2:
fan speed 0-3 (FSP0-FSP3)
Auto mode (Auto)
e.
do (digital output position) do01-do0x***:
ON = enabled
OFF = disabled
➔ 4 and 5 bars indicate setting step 4 rep. 5 is executed.
* The number of available control loops depends on the used X2-controller.
** The number of available analogue outputs depends on the used X2-controller.
*** The number of available digital outputs depends on the used X2-controller.
14. Press (
) to complete the setting of a timed event.
15. Now you are back in menu "program selection" (instruction No. 4).
Start creating the next weekly schedules for program 2 to 12 as
required.
To go back to the previous submenu, press the (
Doc: 70-07-0951A, 20220504
Subjects to alteration
X2-O
PERATIONS
) button (1x).
© Vector Controls LLC, USA
www.vectorcontrols.com
M
T
ANUAL
OUCH
OP ➔
D
ISPLAY
Page 12-18
Advertisement
