Advertisement
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
1.
On/Off Switch not activated
2.
Spark plug cap not connected to
spark plug.
Engine fails
3.
Fuel tank empty
to start.
4.
Fuel is over 30 days old and stale.
5.
Block fuel pipe
6.
Faulty or flooded spark plug
7.
Engine flooded
1.
Choke still on with warm engine
2.
Spark plug cap loose.
3.
Blocked fuel line
4.
Stale fuel
Engine runs
5.
Water or dirt in fuel system
erratic
6.
Dirty air filter
7.
Carburettor operating incorrectly.
8.
High/Low needles incorrectly
adjusted.
1.
Incorrect 40:1 fuel to two-stroke
Engine
oil mixture
overheats
2.
Air flow restricted
3.
Carburettor operating incorrectly.
Engine
hesitation
1.
Spark plug gap incorrect.
at high speed
1.
Spark plug fouled, faulty or gap
incorrect.
Engine idles
2.
Carburettor not functioning
erratically
correctly.
3.
Dirty air filter.
Uneven cut
1.
Blunt saw chain
Chain oil does
1.
Check oil for substandard quality
not lubricate
2.
Check oil passage and ports,
chain
maybe blocked
If you are unable to resolve any issue on your machine, please contact your local approved service dealer, who
can be found at
www.webbgardenpower.co.uk
SOLUTION
1.
Turn machine on.
2.
Connect spark plug cap to spark plug.
3.
Fill with clean, fresh fuel
4.
Carburettor gummed up, take to approved
service dealer for non-warranty repair.
5.
Clean fuel pipe & filter
6.
Clean, adjust or replace spark plug.
7.
Remove spark plug, dry off and reseat.
1.
Deactivate choke.
2.
Connect cap to spark plug and ensure
tight.
3.
Clean fuel pipe and filter
4.
Remove fuel and use fresh fuel.
5.
Drain fuel tank, refill with fresh fuel
6.
Clean air filter
7.
Have carburettor inspected by approved
service dealer and adjusted.
8.
Adjust High/Low needles as advised in this
manual.
1.
Mix correct fuel:oil mixture. Fill fuel tank.
2.
Remove blower housing and clean.
3.
Have carburettor inspected by approved
service dealer and adjusted.
1.
Adjust spark plug gap to between 0.6-
0.8mm
1.
Adjust spark plug gap to between 0.6-
0.7mm
2.
Have carburettor inspected by approved
service dealer and adjusted.
3.
Clean air filter.
1.
Have saw chain sharpened or replaced.
1.
Replace chain oil with correct quality.
2.
Clean all relevant exits.
or contact customerservice@webbgardenpower.co.uk.
31
Advertisement
