Advertisement
GUIDE BAR MAINTENANCE
Guide bar
•
Reverse the bar occasionally to prevent partial wear.
•
The bar rail should always be square. Check for wear of the bar rail. Apply a ruler to the bar and the
outside of a cutter. If a gap is observed between them, the rail is normal. Otherwise, the bar rail is worn.
Such a bar needs to be corrected or replaced.
The table contains the details of the saw chain and guide bar required for your machine.
Pitch
Length
Groove Width
0.325"
16" / 40cm
0.058" / 1.5mm
For replacement, use only approved bars and chains. Use of a non-approved combination, may cause serious
personal injury, damage to the machine and also invalidate your warranty.
1.Ruler 2.Gap
3. No Gap
Guide Bar
Number of
Code
Nose Teeth
168PXBK095
7
Chain
Number of
Code
Drive Links
21BPX066X
66
29
Advertisement
