Advertisement
6. When the engine first fires (false start), turn the choke knob anti-clockwise to open the choke.
7. Repeat from Step 4 until the engine starts.
8. Pull chain brake towards the front handle to release brake. Then, allow the engine to warm up with the
trigger pulled slightly.
CHOKE CLOSED
Cold Start Position
STARTING THE ENGINE (WARM/HOT)
1. Switch the On/Off switch to the 'I' position.
2. Push the chain brake down toward the front to activate. This will stop the chain from rotating.
3. While holding the chainsaw securely on the ground, Grip the starter handle, slowly pull out the cord with
your right hand until you feel some resistance (the starter pawls grip), and now quickly and powerfully pull
the cord. Never twist the starter cord around your hand.
ENGINE WON'T START
If the engine won't start after you have operated the starter several times when cold or hot, the engine may
be flooded with excess fuel. Use the following procedure to clear and start a flooded engine.
1. Remove the spark plug, dry it, and then reinstall it.
2. Install the spark plug carefully by hand, to avoid cross-threading. After the plug is seated tighten 1/8 to 1/4
turn with socket spanner of spark plug to compress the washer.
3. Run through the engine starting procedure as described previously.
STOPPING THE ENGINE
1. Release the throttle trigger, allowing the engine to idle.
2. Switch the On/Off switch to the '0' position.
CHOKE OPEN
Warm Start or Run Position
19
Advertisement
