Download Print this page

Frico Elektra C Manual page 10

Advertisement

GB
Safety instructions
Incorrect installation and/or incorrect usage of the
fan heater can be hazardous.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given instructions or are supervised concerning
use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that
they do not play with the appliance
Warning!
• Always disconnect the fan heater before
opening the cover or doing any electrical
work.
• Incorrect installation can lead to personal
injury.
• Opening the heater cover etc should only be
done by a qualified installer
• This fan heater must not be used next to a
shower, bath or swimming pool.
• Place the fan heater away from flammable
materials
• Ensure that the area around the intake and
exhaust grille is kept free from material
which could obstruct the air flow through
the unit!
• During operation the surfaces of the unit
are hot!
• The unit must not be covered fully or
partially with clothes, or similar materials,
as overheating can result in a fire risk!
• The fan heater is fitted with a cable that, in
the event of damage, must be changed by a
qualified installer.
Type
Description
ELSRT
Control panel with room thermostat
ELSRT4
Control panel with room thermostat (control of 4 units)
KRT1900
External thermostat, IP55
12
Elektra C
Important!
When using the heater as a portable, the brackets
must be turned in order to use them as a
floor stand (see fig 4 on page 3).
The guarantee is only valid if the units are used
in the manner intended by the manufacturer
and in accordance with the installation and
maintenance instructions.
Accessories
For fixed installation the heater can be controlled
by an external control panel with a built in
thermostat 0 – +35°C. It is also possible to use
only an external thermostat to control the heat
output. The ELSRT can only control one unit. For
parallel connection of up to 4 units the ELSRT4
can be used. When ELSRT is being used, the built-
in thermostat must be set to max and the output
selector on the unit to Off
See table below.
.
Dimensions
HxWxD
[mm ]
175x150x100
255x360x110
165x60x57

Advertisement

loading

This manual is also suitable for:

Elc331Elc623Elc633Elc923Elc933Elc1533