Table of Contents
Advertisement
Connecting the Silencer (Optional)
Connecting the Silencer (Optional)
The ProAero+ is supplied with a silencer to reduce the noise of the exhaust from the system.
Installing the silencer is optional, and you can do this at a later time if needed.
To connect the silencer:
1. Place the system slightly forward of its final location, and position the rear wheels of the
system so they are facing towards the front of the system.
2. Place the silencer on the floor behind the system, with the lower part of the silencer facing
the system.
3. Either push the silencer forward so it moves under the system, or roll the system straight
back until it covers the lower part of the silencer completely, and is touching the higher part
of the silencer.
4. Lock the front wheels of the system.
It is difficult to move the system after connecting the silencer, so move the system
as close to the desired location as possible before continuing.
The rear wheels of the system need to be facing forward to allow the silencer to fit
underneath the system.
Figure 3: Silencer positioned behind system
© Copyright 2021 Stratasys. All rights reserved.
Lower part
of silencer
Page 7
Advertisement
Table of Contents
